Rear Heater Hose for 2012-2016 Tesla Motors & More - Gates 12485

$13.99

Vehicles this part fits

    Part number: 12485
    UPC: 770075841845
    Condition: New
    Weight: 0.60 LBS
    Item Package Quantity: 1
    $13.99
    Adding to cart… The item has been added

    Have questions?

    Gates HVAC Heater Hose P/N:12485
    Gates HVAC Heater Hose P/N:12485
    $13.99
    $13.99

    Keep coolant moving to the cabin heat with the GATES heater hose 12485, a factory-molded ThermalPro Premium hose that drops in as a direct-fit replacement for the 2012-2016 Tesla Motors and 2012-2016 Tesla S. This small I.D. molded coolant hose is pre-shaped for today's tighter engine bays and is cataloged for the rear drive inlet-to-tee position, so it follows the factory routing without splicing lengths of straight hose.

    Built to Gates' molded coolant hose standards and close to OEM specs, this GATES molded heater hose can also carry water and air, and is approved for marine use.

    • Construction: EPDM tube, synthetic fiber knit reinforcement, and EPDM cover.
    • Standards: Meets SAE 20R3 Type EC Class D-1 and D-2.
    • Electrochemical resistance: engineered to resist electrochemical degradation, which Gates cites as the leading cause of hose failure.
    • Temperature range: -40°F to 275°F (-40°C to 135°C).

    Do not use for fuel or oil transfer. Gates recommends fitting new hose clamps whenever a new coolant hose is installed.

    Interchange: F10641 · 13485 · R45040 · 104895400A · 104895400B

    Product information is for general reference and may contain errors. See our Disclaimer.

    This part cross-references / interchanges with the following part numbers:

    F10641, 12485, 13485, R45040, 104895400A, 104895400B

    Frequently Asked Questions

    Does this GATES hvac heater hose fit my Tesla?

    Yes, it is a direct-fit replacement for the 2012-2016 Tesla Motors and 2012-2016 Tesla S. Check the "Vehicles it fits" section to confirm the application for your vehicle.

    What is this heater hose made of?

    It uses an EPDM tube, synthetic fiber knit reinforcement, and an EPDM cover, and it meets SAE 20R3 Type EC Class D-1 and D-2 specifications.

    Where does this hose install?

    It is cataloged for the rear drive inlet-to-tee position. Confirm placement against your vehicle's service information before installing.

    What temperature range does this hose handle?

    It is rated from -40°F to 275°F (-40°C to 135°C).

    Should I reuse the old hose clamps?

    Gates recommends installing new hose clamps each time a new coolant hose is fitted. Do not use this hose for fuel or oil transfer applications.

    Reviews

    No reviews yet — be the first to review this product.

    Write a Review