Gates HVAC Heater Hose P/N:18598
Keep coolant flowing between the heater core and engine with the Gates Molded Heater Hose 18054, a factory-molded, OEM-style hose that drops in as a direct-fit replacement on the 2009-2015 Honda Pilot (V6-3.5L). It serves the heater-to-engine (inlet) position, and its pre-formed shape is built to route through today's smaller, tighter engine compartments.
Caution: do not use for fuel or oil transfer applications. Gates recommends replacing the hose clamps each time a new coolant hose is installed. Made in the United States.
Interchange: 14573S · B91001 · 87837 · 79721SZAA00 · 10054
Product information is for general reference and may contain errors. See our Disclaimer.
This part cross-references / interchanges with the following part numbers:
What vehicle does the Gates 18054 heater hose fit?
It is a direct-fit replacement for the 2009-2015 Honda Pilot with the V6-3.5L engine. Check the "Vehicles it fits" section to confirm fitment for your vehicle.
What position does this hose serve?
This molded hose serves the heater-to-engine (inlet) position, pre-formed to route through the vehicle's tight engine compartment.
What is this hose made of?
It uses an EPDM tube with synthetic fiber knit reinforcement and an EPDM cover, meeting SAE 20R3 Type EC Class D-1 and D-2 specifications.
Can I use this hose for fuel or oil?
No. Gates cautions against using it for fuel or oil transfer. It is approved for coolant, water, air and marine applications.
Should I replace the hose clamps too?
Gates recommends replacing the hose clamps each time a new coolant hose is installed for a reliable seal.
No reviews yet — be the first to review this product.
Write a Review
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.