Heater Hose for 2000-2008 Jaguar S-Type - Gates 51344

Be the first to review this product

$21.99

MPN: 51344

UPC: 770075753971

Item Package Quantity: 1

Current Stock:

Quantity:

Adding to cart… The item has been added

Have questions?

Ask an Expert

Gates HVAC Heater Hose P/N:51344

$21.99

Description

Route coolant from the water pump to the thermostat with the Gates heater hose 51344, a premium molded coolant hose that installs as a direct-fit replacement on the 2000-2008 Jaguar S-TYPE with the V6-3.0L engine. Pre-shaped to the factory routing, this Gates hvac heater hose drops into the water-pump-to-thermostat position for a properly sealed connection.

EPDM construction: EPDM tube, synthetic fiber knit reinforcement, and a heat-, ozone- and chemical coolant-resistant EPDM cover.
Built to survive the cooling system: specifically-engineered materials resist collapse under vacuum and are designed to resist electrochemical degradation, a leading cause of hose failure.
Molded to fit: this pre-shaped, molded heater hose is formed to the application to help ensure a properly sealed fit.
Standards & temperature: meets the requirements of SAE 20R4 class D2 and DIN 73411 class A (except for tolerances); rated for a temperature range of -40°F to +257°F (-40°C to +125°C).

Centerline length measures 8.03 in (204 mm) with 1.44 in (37 mm) inside diameter at each end. Do not use for fuel or oil transfer applications. Gates recommends replacing hose clamps each time a new coolant hose is installed. Country of origin: United States.

Interchange: 20791S · 72854 · B72854 · C72297 · XR810208 · XW439K493AA · R39105 · CHE0135R · URO007283

Manufacturer's Description

Product Specs

Buyer's Guide

Interchange Part Numbers

This part cross-references / interchanges with the following part numbers:

20791S, 72854, B72854, C72297, XR810208, XW439K493AA, 51344, R39105, CHE0135R, URO007283

Frequently Asked Questions

What vehicle does the Gates 51344 heater hose fit?

It is a direct-fit replacement for the 2000-2008 Jaguar S-TYPE with the V6-3.0L engine. Check the Buyer's Guide tab to confirm the fit for your vehicle.

Where on the cooling system does this hose install?

This molded hose is shaped for the water-pump-to-thermostat position, routing coolant between those points.

What is this Gates molded heater hose made of?

It uses an EPDM tube with synthetic fiber knit reinforcement and a heat-, ozone- and chemical coolant-resistant EPDM cover.

What temperature range is the hose rated for?

It is rated for -40°F to +257°F (-40°C to +125°C) and meets SAE 20R4 class D2 and DIN 73411 class A requirements (except for tolerances).

Should I replace the clamps when installing this hose?

Yes. Gates recommends replacing the hose clamps each time a new coolant hose is installed. Do not use this hose for fuel or oil transfer applications.