Gates Intercooler Hose Kit P/N:26231
Gates 26224 intercooler hose kit for the 2005-2009 Dodge Ram 2500 6-cylinder 5.9L, the 2007-2009 Ram 2500 6-cylinder 6.7L and other vehicles replaces the turbocharger hose that joins the turbocharger to the pipe and the pipe to the engine. The molded kit replaces the full hose system as one set. It was brought out to address problems with original-equipment replacement hoses.
A hose that is cracked, split or wet with oil, or a clamp joint that looks loose, can mean boost is leaking. Look the hose over with the engine off and cool. If a failed hose is the cause, this kit replaces it, but lost power can have other causes, so find the cause first.
This kit also fits the 2007-2016 Chevrolet Express 2500 V8 6.6L and the 2007-2016 Chevrolet Express 3500 V8 6.6L. If your truck or van is not named here, look it up in the "Vehicles it fits" section.
Fit and size
Build and materials
One molded hose and two T-bolt clamps. This listing is one kit, and the vehicle takes one.
Interchange: 55056538AB · 55056538AC · 55056720AB · 15849822 · 25836156
Product information is for general reference and may contain errors. See our Disclaimer.
This part cross-references / interchanges with the following part numbers:
Will the Gates 26224 fit the 2007-2016 Chevrolet Express 2500 V8 6.6L?
Yes. Gates 26224 is an intercooler hose kit that fits the 2007-2016 Chevrolet Express 2500 V8 6.6L. If your vehicle is not named, look for it in the "Vehicles it fits" section.
Does the Gates intercooler hose come with clamps?
Yes. Gates 26224 comes with one molded hose and two T-bolt clamps. The clamps have a stainless steel band and bridge that resist corrosion.
What size are the ends on this intercooler hose kit?
Both ends have a 2.72 in (69 mm) inside diameter. The hose is 7.44 in (189 mm) long along its centerline.
What can a worn intercooler hose kit look like?
A soft or swollen hose, oil seeping at a joint, or less power while driving can all be signs. A shop can pressure-test the boost system to find a leak.
What torque do the T-bolt clamps on this hose kit need?
The recommended torque is 75 inch-pounds. The clamps use a .25 in. - 28 T-bolt with a .4375 in. hex-head nut with a nylon insert.
No reviews yet — be the first to review this product.
Write a Review
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.