Gates Radiator Coolant Hose P/N:51836
Gates 24493 lower radiator coolant hose for the 2008-2010 Ford F-250 Super Duty V8 5.4L and other vehicles carries engine coolant through a molded, modular body. This Gates coolant hose comes with a male quick connector and is made to fit specific applications.
A worn radiator coolant hose can show up as coolant leaks at the hose or its fittings, a hose that feels soft, swollen or cracked when the engine is cool, or a coolant level that keeps dropping (check it only with the engine cool). Before you replace this hose, rule out a loose clamp or a leak from the radiator or water pump, since either one leaves coolant loss that looks the same.
This hose is a direct-fit replacement for the 2008-2010 Ford F-250 Super Duty V8 5.4L and the 2008-2010 Ford F-350 Super Duty V8 5.4L.
Fit and size
Build and materials
One radiator coolant hose with a male quick connector. This listing is one hose, and these vehicles each need just one.
Interchange: 8C3Z 8286 D · 27220X · 72638 · E72638 · 66450 · KM4955 · 17141
Product information is for general reference and may contain errors. See our Disclaimer.
This part cross-references / interchanges with the following part numbers:
Is the Gates radiator coolant hose 24493 right for the 2008-2010 Ford F-350 Super Duty V8 5.4L?
Yes. Gates 24493 is a lower radiator coolant hose that fits the 2008-2010 Ford F-350 Super Duty V8 5.4L, and it also fits the 2008-2010 Ford F-250 Super Duty V8 5.4L.
What is this Gates molded coolant hose made of?
Gates 24493 has an EPDM tube with synthetic fiber knit reinforcement and a heat-, ozone- and chemical coolant-resistant EPDM cover. Its materials are listed as EPDM, plastic and steel.
Does this Gates lower radiator hose come with its quick connector?
Yes. This lower hose comes with one male quick connector and has no branch connectors.
How long is this radiator coolant hose and what are its end diameters?
The centerline length is 35 in (889 mm). End 1 has a 1.73 in (44 mm) inside diameter and end 2 has a 2.24 in (57 mm) inside diameter.
Should I reuse my old clamps on this radiator coolant hose?
No. Clamps should be replaced whenever a new coolant hose is fitted. This hose is not for fuel or oil transfer.
No reviews yet — be the first to review this product.
Write a Review
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.