Dorman - OE Solutions HVAC Heater Hose Connector P/N:800-917HP
Reconnect a leaking or broken heater hose run with the Dorman - OE Solutions Heater Hose Connector 800-416, a plastic 90-degree fitting that joins two 5/8 in. heater hose sections. It fits many vehicles, among them the 2003-2010 Ford Mustang, 2007-2009 Dodge Ram 2500 and 2013-2020 Ford Fusion. See the "Vehicles it fits" section for the full list.
Depending on the application, this HVAC heater hose connector is used at the heater inlet, the thermostat-to-heater line, an auxiliary heater, the hybrid reservoir-to-hybrid radiator line, or the battery cooling pump inlet or outlet. Dorman built it to fit and work like the original equipment connector, and it is intended to provide a leak-free connection.
If a cracked or broken fitting is the source of your coolant leak, this Dorman heater hose fitting replaces it. When installing this Dorman hose connector, follow the vehicle service information for draining, refilling and bleeding the coolant.
Interchange: 15-34069
1534069 · 5058729AD · 5058729AE · 5058729AG · 5058729AH · 55056711AC · 68068296AB · 80462 · 4201 · XC2Z18B402BA · 28503 · 15139564 · 65650
Product information is for general reference and may contain errors. See our Disclaimer.
This part cross-references / interchanges with the following part numbers:
What does this heater hose connector do?
It joins two 5/8 in. heater hoses at a 90-degree bend so coolant can pass through. Depending on the vehicle, it sits at a position such as the heater inlet or the thermostat-to-heater line.
What size is this Dorman 5/8 in. heater hose connector?
It is a 5/8 in. x 5/8 in. connector with a 90-degree bend and a plastic body.
Will it fit my 2003-2010 Ford Mustang?
Yes. The 2003-2010 Ford Mustang is a listed application, as are the 2007-2009 Dodge Ram 2500 and 2013-2020 Ford Fusion. Check the "Vehicles it fits" section for the full fitment list.
What are signs a heater hose connector may need replacing?
Coolant leaking at the fitting, a cracked or broken connector, a dropping coolant level or weak heater output may indicate a failed connector. Other parts can cause these signs, so diagnose the leak before replacing.
How is this connector installed?
With the engine cool, drain coolant as the service procedure directs, remove the old connector, fit the hoses and secure them, then refill and bleed the cooling system per the vehicle service information.
No reviews yet — be the first to review this product.
Write a Review
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.