Keep the grease in and the grit out of your cv joint Tacoma setup with the Mevotech Duraflex CV Joint Boot (P/N: DX860). This front inner CV joint boot drops in as a direct-fit replacement for the 1996-2004 Toyota Tacoma, sealing the constant-velocity joint so it can transfer power smoothly through the drive axle while flexing with steering and suspension travel.
A torn or cracked boot lets grease sling out and lets contaminants in — signs this front inner boot may need replacing include grease flung around the inner joint area and clicking or clunking when accelerating or turning. If a failed boot is the cause, replacing it before the joint runs dry helps protect the CV joint. Confirm the fit for your vehicle in the Buyer's Guide tab.
Interchange: 103-2819 · 86-2321
1032819 · 862321 · QBK860 · CVB860
This part cross-references / interchanges with the following part numbers:
What vehicles does the DX860 CV joint boot fit?
It is a direct-fit replacement for the 1996-2004 Toyota Tacoma. Check the Buyer's Guide tab to confirm the fit for your specific vehicle.
Is this a front or rear boot?
This is a front inner CV joint boot, cataloged for the front inner position.
What is the Toyota Tacoma cv joint boot made of?
It uses a premium neoprene boot that holds grease in place and blocks out dirt, water and road debris.
Does it come with everything needed to install it?
It includes clamps and snap rings for installation, plus a grease tube to pack the joint during service.
How do I know if my CV joint boot needs replacing?
Signs include grease flung around the inner joint area and clicking or clunking when accelerating or turning. Diagnose the cause before replacing.
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
