Help cushion your suspension with the Mevotech Supreme Coil Spring Insulator MK160042, a direct-fit 1999-2004 Jeep Grand Cherokee coil spring insulator. It serves as the rear lower insulator on the 1999-2004 Jeep Grand Cherokee, sitting between the coil spring and its perch to cushion the spring and help isolate road noise and vibration. See the "Vehicles it fits" section for engine-level fitment.
A coil spring insulator prevents metal-to-metal contact between the spring end and its seat. When the original insulator hardens, cracks, or crushes, you may notice creaking, popping, or clunking from the suspension when going over bumps or loading the spring — signs it may be time to replace it.
- Natural rubber construction: all moulded parts use 100% natural rubber for durability.
- Rear lower fitment: serves as the rear lower coil spring insulator on the listed applications.
- Direct-fit replacement: a direct-fit replacement for the rear lower coil spring insulator on the 1999-2004 Jeep Grand Cherokee.
Insulators wear on both sides of the axle, so inspect the opposite side and replace as needed for a balanced ride.
Interchange: TD4647W · CSI96575 · 52088402 · 52088402AB · K160042 · JSP5130S
Product information is for general reference and may contain errors. See our Disclaimer.
This part cross-references / interchanges with the following part numbers:
TD4647W, CSI96575, 52088402, 52088402AB, K160042, MK160042, JSP5130S
Frequently Asked Questions
What vehicles does the MK160042 coil spring insulator fit?
It fits the 1999-2004 Jeep Grand Cherokee. Check the "Vehicles it fits" section to confirm the exact application for your vehicle.
Where is this insulator located?
It is the rear lower coil spring insulator, seating between the coil spring end and its perch on the listed applications.
What is the Mevotech Supreme insulator made of?
All moulded parts use 100% natural rubber, which the manufacturer states provides the best durability.
What are signs my coil spring insulator needs replacing?
Creaking, popping, or clunking from the suspension over bumps, or a hardened, cracked, or crushed insulator, may be signs it should be replaced. Diagnose the cause first.
Should I replace both sides at once?
Insulators wear on both sides of the axle, so it is good practice to inspect the opposite side and replace it as needed for a balanced ride.
