Keep the steering and suspension of your car tight and predictable with the Mevotech Supreme Front Lower Suspension Ball Joint MK80992, a direct-fit replacement for the 2004-2011 Ford Focus (see the Buyer's Guide tab for engine-level details). This ball joint pivots the front lower control arm and steering knuckle, letting the wheel steer and travel while holding the geometry in place — when a worn joint is the cause of clunking over bumps, loose steering, or uneven tire wear, replacing it addresses that source.
Mevotech Supreme parts are engineered in-house with application-specific upgrades aimed at high-usage commercial and passenger vehicles, SUVs, fleets and working trucks.
Simple to service: includes a 180-degree SAE grease fitting for easy relubrication.
Fasteners included: ships with an application-specific pinch bolt and locking nut to speed the install.
Resists corrosion: a protective surface treatment helps guard against rust build-up.
Sealed against contaminants: a pre-installed dust boot helps keep water and debris out of the internal components.
Backed by extensive in-house and third-party durability testing. A quality ball joint replacement for your Ford Focus that installs on the front lower position.
Frequently Asked Questions
What is this Ford Focus ball joint and what does it do?
It is the Mevotech Supreme front lower suspension ball joint MK80992. It pivots the lower control arm and steering knuckle so the front wheel can steer and move through suspension travel while holding alignment geometry.
Does the MK80992 fit my Focus ST?
This ball joint is cataloged for the 2004-2011 Ford Focus. Check the Buyer's Guide tab against your specific year, trim and engine to confirm it applies to your vehicle before ordering.
Does it include mounting hardware?
Yes. It comes with an application-specific pinch bolt and locking nut, plus a 180-degree SAE grease fitting, so you have the fasteners needed to install the joint.
What are the signs I may need a ball joint replacement on my Ford Focus?
Clunking or knocking over bumps, loose or wandering steering, and uneven front tire wear can indicate a worn ball joint. Have the cause diagnosed, since these symptoms can come from other parts too.
Does it come with a dust boot and corrosion protection?
Yes. A pre-installed dust boot helps keep water and debris out of the internal components, and a protective surface treatment helps guard against rust build-up.
Suspension Ball JointMevotech Supreme Parts™ are engineered in-house, with application-specific upgrades for increased durability and performance. Mevotech Supreme ball joints are built for...
Suspension Ball JointMevotech Supreme Parts™ are engineered in-house, with application-specific upgrades for increased durability and performance. Mevotech Supreme ball joints are built for...
Keep the steering tight and the front suspension properly located with the Mevotech Supreme Front Lower Suspension Ball Joint MS30518 — a direct-fit Nissan Rogue ball joint that pivots the lower...
Keep your front suspension tight and controlled with the Mevotech Supreme Suspension Ball Joint (MK8611T) — a direct-fit Ford E-150 ball joint for the front lower position. It drops in on the...
Suspension Ball JointMevotech Supreme Parts™ are engineered in-house, with application-specific upgrades for increased durability and performance. Mevotech Supreme ball joints are built for...
WARNING:
These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov.
