Keep the front suspension located and damp out road vibration with the Mevotech Supreme Suspension Control Arm Bushing MS604126. It drops in as a direct-fit replacement for the front lower forward position on the 2005-2013 Honda Odyssey, cushioning the control arm where it pivots so the wheel stays properly aligned. If a worn or cracked original bushing is behind your clunking, imprecise steering, or uneven tire wear, this is the piece that renews that connection.
- High-grade natural rubber construction: Made from premium natural rubber for increased durability against the loads and flex the bushing sees.
- OE-quality fit and performance: Built to deliver OE-quality fit and performance on the listed application.
- Front lower forward position: Cataloged for the front lower control arm's forward mounting point, isolating vibration and helping locate the arm through its travel.
A tired control arm bushing lets the arm shift under braking and cornering, which can show up as clunks, wandering, or vibration; if that bushing is the cause, this replaces it. Inspect both sides and replace as directed by the vehicle service procedure for balanced results.
Interchange: 19472693 · TD5822W · BC59079 · BC59339 · 51350SHJA01 · 51350SHJA02 · 51350SHJA03 · 51360SHJA02 · 51360SHJA03 · BU19466 · K201654 · 22976 · X17BU0538 · JBU2431 · JBU2471
This part cross-references / interchanges with the following part numbers:
Frequently Asked Questions
What vehicles does the MS604126 fit?
It is a direct-fit replacement for the front lower forward control arm bushing on the 2005-2013 Honda Odyssey. See the Buyer's Guide tab for engine-level detail.
What is this bushing made of?
It uses high-grade natural rubber construction for increased durability against the loads and flex the control arm bushing experiences in service.
What position is this bushing for?
It is cataloged for the front lower forward control arm mounting point, where it cushions vibration and helps locate the arm through its travel.
What are signs my control arm bushing may need replacing?
Clunking over the suspension, wandering or imprecise steering, and uneven tire wear can point to a worn bushing. Diagnose the cause before replacing.
Should I replace both sides at once?
Replacing the bushings on both sides together is good practice for balanced suspension response. Follow the vehicle service procedure for your application.
Write a Review