Smooth out a worn, bouncy back end and make strut replacement on your Toyota Highlander quicker with the Monroe Quick-Strut 172485 Rear Right Suspension Strut and Coil Spring Assembly. This complete strut and coil spring assembly ships as a single, fully assembled unit — preassembled upper strut mount, coil spring and strut — so no spring compressor is needed. It fits the rear right position on the 2008-2013 Toyota Highlander and 2013-2015 Toyota Venza; see the Buyer's Guide tab for engine-specific coverage.
Interchange: LS5494032R · 34TY1198
This part cross-references / interchanges with the following part numbers:
What vehicles does the Monroe 172485 Quick-Strut fit?
It's a direct-fit rear right suspension strut and coil spring assembly for the 2008-2013 Toyota Highlander and 2013-2015 Toyota Venza. See the Buyer's Guide tab for engine-specific coverage.
Do I need a spring compressor to install this Toyota Venza strut assembly?
No. The 172485 arrives fully assembled with the upper strut mount, coil spring and strut preassembled, so no spring compressor is required for the strut replacement.
What position does this strut assembly cover?
This unit is the rear right (passenger-side) strut and coil spring assembly. It replaces one corner, so order the quantity you need for your repair.
Should I replace struts in pairs?
Replacing both sides of an axle together is recommended for balanced, even ride and handling, though it isn't required. This listing covers the rear right unit.
What are signs my rear strut may need replacing?
Common signs include excessive bouncing, body sway, sagging ride height, or noise and harshness over bumps. Diagnose the cause before ordering, as these symptoms can have other causes.
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
