MOOG Chassis Products Suspension Ball Joint P/N:K80606

Keep the front suspension tight and the steering responsive with the MOOG Chassis Products Front Lower Suspension Ball Joint K80606. It installs as a direct-fit replacement for the 2005-2017 Honda Odyssey — see the Buyer's Guide tab for the full engine-level fitment. A ball joint pivots the steering knuckle against the lower control arm; worn joints can show up as clunking on acceleration or deceleration, uneven tire wear, or loose, wandering steering, so if the original joint is the cause, this replaces it.

• Problem Solver Gusher Bearing: a metal-to-metal design that adds strength and lets grease flow across the bearing surface for reduced friction.
• Greaseable socket: lets fresh lubricant flush out contaminants to help reduce corrosion and wear.
• Belleville preload washer: helps keep the bearing package tight as the bearings wear.
• Pressed-in cover plate: a patented sealed cover helps keep debris out and minimize looseness for reduced bearing wear.

The ball studs are heat treated to match or exceed OE requirements to help resist premature failure and improve fatigue strength, and precision tolerances are designed for straightforward installation and steering alignment. Ball joints are recommended for replacement in matched pairs on the axle for balanced steering.