Clamp the brake pads firmly against the rotor with the Nugeon brake caliper 97-01550B (9701550B), a remanufactured front-left fixed caliper that installs as a direct-fit replacement for the 1988-1991 Toyota 4RUNNER [All] and 1988-1989 [V6-3.0L], plus the 1988-1995 Toyota PICKUP [All], 1989-1990 [L4-2.4L], and 1988-1990 [V6-3.0L].
Uses a line inlet fitting with an M10-1.0 inlet thread and a single banjo bolt. This is the FRONT LEFT unit, sold individually — for even, balanced braking it is best practice to replace the caliper on both front wheels together as a matched pair. Remanufactured from a Nissin caliper core. Country of origin: Mexico. Consult the vehicle service information for the correct fasteners and whether they may be reused.
Will this Nugeon caliper fit my Toyota 4RUNNER?
Yes. This 4RUNNER caliper is a direct-fit replacement for the 1988-1991 Toyota 4RUNNER, front-left position. See the Buyer's Guide tab to confirm your engine and year.
Are brake pads included with this caliper?
No. Brake pads, anti-squeal shims, and wear sensors are not included. It does include the bleeder screw, caliper slides, dust boots, crush washers, and caliper/pad mounting hardware.
What position is this caliper for?
This is the FRONT LEFT disc brake caliper. It is sold individually as one caliper.
Should I replace both Toyota 4RUNNER calipers at once?
It's sold individually, so two per axle is recommended, not required. Replacing both front calipers together helps promote even, balanced braking.
What type of caliper is this?
It's a remanufactured fixed caliper with four steel pistons (42.77 mm / 1.68 in OD) in a cast iron housing with a rust-preventative finish.
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
