TERREPOWER 97-17031A right brake caliper for the 2003-2011 Isuzu FTR and other vehicles clamps the brake pads against the rotor to slow the wheel. This is a remanufactured fixed disc brake caliper for the right side of the axle.
Uneven pad wear, fluid around the dust boots or a pull to one side when braking can point to a failing caliper. A worn rotor, worn pads or a damaged brake hose can be behind those signs too, so find the cause before buying. This listing is one right-side caliper; the left side is a separate part, and both sides of an axle are normally replaced together. Each right-side wheel position takes one.
This caliper is listed for a wide range of Isuzu, Chevrolet and GMC models, led by the 2003-2011 Isuzu FTR, the 2003-2011 Isuzu FVR and the 2004-2011 Isuzu FXR. If your vehicle is not named here, find your model and year in the "Vehicles it fits" section before you order.
Fit and size
Build and materials
One remanufactured brake caliper with its bleeder screw, dust boots, mounting hardware and crush washers. Not included: brake pads, bracket, bracket mounting bolts, mounting bolts, caliper slides, anti-squeal shims, wear sensors, bleeder screw cap and caliper and pad hardware. Plan on new bolts for the bracket and caliper, since the old ones may not be reusable.
Is the TERREPOWER 97-17031A caliper right for the 2003-2011 Isuzu FTR?
Yes. The TERREPOWER 97-17031A right brake caliper is listed for the 2003-2011 Isuzu FTR, and the "Vehicles it fits" section covers the other models it suits.
Does this remanufactured caliper come with brake pads?
No. This caliper comes with its bleeder screw, dust boots, mounting hardware and crush washers. Pads, bracket, bracket bolts and slides are not included.
How big are the pistons on the TERREPOWER 97-17031A?
The TERREPOWER 97-17031A has four phenolic pistons, each 64 mm (2.52 in) in diameter, in a fixed caliper body.
How can I tell if a fixed caliper is leaking or dragging?
During a brake service with the wheel off, look for fluid around the dust boots and bleeder screw, uneven pad wear or heavy rust on the housing. A shop can test a dragging brake.
What thread does the inlet on this caliper use?
The inlet is a banjo bolt fitting with a 7/16-24 thread. The bleeder screw is 7/16-24 x 1.57.
No reviews yet — be the first to review this product.
Write a Review
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
