Nugeon 99-00582A front right brake caliper for the 2004-2007 Nissan Titan and other vehicles squeezes the pads against the rotor to slow the wheel. This remanufactured Nugeon brake caliper is a floating design.
A disc brake caliper that sticks or leaks can show up as the vehicle pulling to one side, uneven pad wear or brake fluid at the wheel. Before you replace the caliper, rule out worn pads, a collapsed hose or a seized slide as the source of the pull. Front calipers are normally replaced together as a pair; this listing is one caliper for the front right, and the front left is ordered separately. The 2005-2006 Nissan Armada takes one on the front right.
This caliper is listed for a wide range of Nissan and Infiniti models, led by the 2004-2007 Nissan Titan, the 2005-2006 Nissan Armada and the 2004-2006 Infiniti QX56. Open the "Vehicles it fits" section to check your exact model and engine.
Fit and size
Build and materials
One remanufactured brake caliper with its mounting bracket, slides, dust boots, caliper and pad hardware, bleeder screw and cap, banjo bolt and crush washers. Brake pads, anti-squeal shims, wear sensors and bracket mounting bolts are not included, and the old bolts may not be reusable, so plan on new ones.
Interchange / FMSI:
FMSI: D1015
Is this a Nissan Titan brake caliper for the front right of a 2004-2007 Nissan Titan?
Yes. Nugeon 99-00582A is the front right caliper, listed for the 2004-2007 Nissan Titan at one caliper per application.
Is this Armada brake caliper correct for the 2005-2006 Nissan Armada?
Yes, this front right caliper is listed for the 2005-2006 Nissan Armada at one per application, and the front left side is a separate part.
Does the Nugeon caliper come with the bracket and bleeder screw?
Yes, it includes the mounting bracket, slides, dust boots, bleeder screw and cap, banjo bolt and crush washers; pads, anti-squeal shims and bracket mounting bolts are not included.
What piston size and bleeder thread does this front right caliper have?
On Nugeon 99-00582A the two pistons are 51 mm (2.008 in) across and the bleeder screw thread is M10-1.0. The banjo bolt inlet is M10 - 1.0.
Which cast numbers are on this Nugeon front right caliper?
The housing cast number is 262 569 and the bracket cast number is 262 536. You can read them against the numbers cast into your old caliper.
No reviews yet — be the first to review this product.
Write a Review
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
