Nugeon 99-00830A rear brake caliper for the 2005-2010 Kia Optima and other vehicles squeezes the brake pads against the rotor to slow the wheel. It is a remanufactured Nugeon brake caliper, also called a disc brake caliper, made for the rear wheels.
A sticking caliper can show up as uneven pad wear at the rear, a pull to one side under braking, or brake fluid around the dust boot. A worn rotor, worn pads or a collapsed brake hose can be behind these signs too, so find the cause before buying a caliper.
This caliper is listed for a wide range of Kia and Hyundai models, led by the 2005-2010 Kia Optima, the 2006-2008 Hyundai Sonata and the 2005-2010 Kia Sportage.
Fit and size
Build and materials
One caliper with its bracket, caliper slides, dust boots, bleeder screw, crush washers, and caliper and pad hardware. Brake pads, anti-squeal shims, wear sensors, the bleeder screw cap and the bracket mounting bolts are not included, so plan on new bolts. This listing is one caliper for a rear wheel; the other rear side takes its own, and the two are normally replaced together.
Is this a caliper for the 2006-2008 Hyundai Sonata?
Yes, Nugeon 99-00830A is listed for the 2006-2008 Hyundai Sonata as a rear brake caliper. If your car is not named on this page, look for it in the "Vehicles it fits" section.
What hardware is included with this rear brake caliper?
The bracket, caliper slides, dust boots, bleeder screw, crush washers, and caliper and pad hardware are included. Brake pads, anti-squeal shims, wear sensors and mounting bolts are not.
How do I tell if a rear caliper is sticking or leaking?
Uneven pad wear on one rear side seen during a brake service, a pull to one side when braking, or fluid around the dust boot can be signs. A shop can test whether the caliper is the cause.
Is the Nugeon caliper 99-00830A made of cast iron?
Yes, the Nugeon 99-00830A has a cast iron housing with a rust-preventative finish and a steel piston. It is a remanufactured floating caliper made in Mexico.
What thread does the banjo inlet on this rear caliper use?
The banjo inlet fitting has an M10-1.0 x 23.4 mm inlet port thread. The included bleeder screw is M10-1.0.
No reviews yet — be the first to review this product.
Write a Review
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
