Nugeon 99-00843A rear right brake caliper for the 2006-2008 Hyundai Sonata and other vehicles clamps the brake pads against the rotor to slow the wheel. This Nugeon caliper is remanufactured and has a floating design.
A caliper that sticks or leaks can show up as the vehicle pulling to one side, uneven pad wear or brake fluid near the wheel. Worn pads, a damaged rotor or a swollen brake hose can be behind those signs too, so find the cause before buying. The rear axle has one caliper on each side; this listing covers the right, and the left is a separate part that is normally replaced along with it.
This brake caliper is a direct-fit replacement for the 2006-2008 Hyundai Sonata and the 2006-2009 Hyundai Azera.
Fit and size
Build and materials
One brake caliper with its mounting bracket, caliper slides, dust boots, caliper and pad hardware, bleeder screw and crush washer. Brake pads, anti-squeal shims, wear sensors, the bleeder screw cap and the mounting bolts, including the bracket mounting bolts, are not included, so plan on new bolts because the old ones may not be reusable.
Is this the rear right caliper for the 2006-2008 Hyundai Sonata?
Yes. Nugeon 99-00843A fits the rear right of the 2006-2008 Hyundai Sonata and the 2006-2009 Hyundai Azera. The rear left side is a separate part.
Does this Nugeon brake caliper come with pads and bracket bolts?
No. It includes the bracket, slides, dust boots, bleeder screw and crush washer, but pads, anti-squeal shims, wear sensors and the bracket mounting bolts are not included.
Is this disc brake caliper a floating or fixed design?
It is a floating design. Nugeon 99-00843A has one steel piston that measures 33.88 mm (1.33 in) across.
Is it safe to keep driving with a leaking rear right brake caliper?
No. Leaking brake fluid or a dragging caliper needs prompt attention, so have the brakes checked and the caliper replaced promptly instead of driving on it.
Which thread sizes do the banjo inlet and bleeder screw on the 99-00843A use?
The banjo inlet port thread is M10-1.0 x 23.4 mm and the bleeder screw thread is M10-1.0. The bleeder screw is included; its cap is not.
No reviews yet — be the first to review this product.
Write a Review
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
