Nugeon 99-01703A rear right brake caliper for the 2014-2019 Toyota Corolla and other vehicles slows the wheel by clamping the brake pads against the rotor. This remanufactured disc brake caliper is driven by brake fluid pressure on its piston.
A pull to one side under braking, a rear wheel that drags or fluid weeping at the piston boot can point to a worn or sticking caliper, though the rear brake hose or the pads may be behind them, so sort out which before you buy.
This caliper fits the 2009-2011 and 2014-2019 Toyota Corolla, the 2009-2014 Toyota Matrix and the 2009-2010 Pontiac Vibe, and each takes one for the rear right position. This listing is one caliper; the rear left is its own part, and the two sides are normally replaced together.
Fit and size
Build and materials
One brake caliper with its mounting bracket, caliper slides, dust boots, caliper and pad hardware, bleeder screw and crush washer. Brake pads, wear sensors, anti-squeal shims, the bleeder screw cap and mounting bolts are not included, so plan on new bracket bolts, since the old ones may not be reusable.
Is the Nugeon 99-01703A a caliper for the 2014-2019 Toyota Corolla?
Yes. This rear right Nugeon 99-01703A fits the 2009-2011 and 2014-2019 Toyota Corolla, and each takes one for the rear right position.
Is this one of the brake calipers for the 2009-2014 Toyota Matrix?
Yes. This rear right brake caliper fits the 2009-2014 Toyota Matrix, one per car for that position. The rear left side is a separate part.
What comes with the Nugeon caliper 99-01703A, and are pads included?
This brake caliper comes with its bracket, slides, dust boots, hardware, bleeder screw and crush washer. Brake pads, wear sensors and mounting bolts are not included.
Is the Nugeon brake caliper a floating or fixed design?
Nugeon 99-01703A is a floating caliper with a single steel piston, 38.07 mm (1.5 in) across, and a banjo inlet fitting.
What cast numbers does the 99-01703A carry?
This brake caliper's housing cast number is 4628 38 and its bracket cast number is 4207. The inlet is a banjo fitting with an M10-1.0 x 23.4 port thread.
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
