Nugeon 99-01718B front right brake caliper for the 2010-2019 Toyota Highlander and other vehicles squeezes the brake pads against the rotor to slow the wheel. This remanufactured Nugeon brake caliper, also called a disc brake caliper, is a floating design.
Pulling to one side, a wheel that drags or fluid around the piston boot can mean this caliper is worn out, though a collapsed brake hose or a warped rotor can produce similar signs, so find the cause before you replace it.
As a brake caliper for the 2010-2015 Lexus RX350, it also fits the 2011-2020 Toyota Sienna; the front right position takes a single caliper. This listing is one caliper; the front left is a separate part, and both sides are normally replaced together. If your vehicle is not named here, look up its year and model on the Buyer's Guide tab.
Fit and size
Build and materials
One remanufactured front right brake caliper with its mounting bracket, caliper slides, dust boots, bleeder screw, crush washers and pad hardware. Brake pads, anti-squeal shims, wear sensors, a bleeder screw cap and the bracket mounting bolts are not included; plan on new bolts, since the old ones may not be reusable.
Interchange / FMSI:
FMSI: D1324
Is Nugeon 99-01718B a Toyota Sienna brake caliper for the 2011-2020 model years?
Yes. Nugeon 99-01718B is a front right brake caliper for the 2011-2020 Toyota Sienna. The front left side is ordered separately.
Does this Toyota Highlander caliper cover the front right on 2010-2019 models?
Yes. Nugeon 99-01718B fits the front right of the 2010-2019 Toyota Highlander; the left side needs its own caliper.
Does this Nugeon caliper come with brake pads?
No. Pads, anti-squeal shims and wear sensors are not included. It comes with its bracket, slides, dust boots, bleeder screw, crush washers and pad hardware, but not the bracket mounting bolts.
What size is the inlet on this front right brake caliper?
The inlet is a banjo fitting with an M10-1.0 x 27.32 port thread. The bleeder screw thread is M7-1.0.
Is this front right caliper a floating or fixed design?
Floating. This remanufactured caliper has two steel pistons, 44.3 mm in outside diameter, and a cast iron casting with a rust-preventative finish.
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
