Nugeon 99-01724A rear right brake caliper for the 2010-2015 Toyota Prius and other vehicles presses the pads against the rotor to slow the wheel. This remanufactured disc brake caliper replaces the one on the rear right wheel.
- Floating caliper with a single 38 mm steel piston
- Aluminum casting with a rust-preventative finish
- Banjo bolt inlet with an M10-1.0 x 23.4 port thread
- Bleeder screw with an M10-1.0 thread and a bleeder screw cap
Quick facts
- Part: Nugeon 99-01724A brake caliper
- Also called: disc brake caliper
- Fits: 2010-2015 Toyota Prius and other vehicles
- Position: Rear right
- Material: Aluminum (casting)
- Condition: Remanufactured
Pulling to one side under braking, fluid around the caliper or uneven pad wear can mean a sticking or leaking caliper. These signs alone do not prove the caliper is at fault; a collapsed brake hose can cause them too. This listing is one caliper for the rear right, with one on each side of the rear axle; the rear left is ordered separately, and both sides are normally replaced together.
Fits
It is a direct-fit replacement for the 2010-2015 Toyota Prius and the 2012-2015 Toyota Prius Plug-In.
Specifications
Fit and size
- Position: rear right
- Quantity per application: 1
- Piston diameter: 38 mm (1.50 in)
- Piston quantity: 1
- Inlet fitting: banjo bolt, M10-1.0 x 23.4 port thread
- Bleeder screw thread: M10-1.0
Build and materials
- Type: floating caliper, remanufactured
- Casting material: aluminum
- Piston material: steel
- Finish: rust preventative
- Country of origin: Mexico
In the box
One caliper with its mounting bracket, caliper slides, dust boots, caliper and pad hardware, bleeder screw with cap and crush washer. Brake pads, anti-squeal shims, wear sensors and bracket mounting bolts are not included, so plan on new mounting bolts.
Interchange / FMSI:
FMSI: D1423E
Frequently Asked Questions
Is this Prius brake caliper the right one for the 2012-2015 Toyota Prius Plug-In?
Yes. Nugeon 99-01724A is the rear right brake caliper for the 2012-2015 Toyota Prius Plug-In and also for the 2010-2015 Toyota Prius.
Is this Nugeon brake caliper remanufactured?
Yes. It is a remanufactured caliper with an aluminum casting and a rust-preventative finish.
What comes with this Nugeon caliper?
Nugeon 99-01724A comes with the bracket, slides, dust boots, hardware, bleeder screw with cap and crush washer. Pads, shims, wear sensors and bracket mounting bolts are not included.
What size is the piston and the bleeder thread on this rear right caliper?
The single steel piston is 38 mm (1.50 in) across, and the bleeder screw thread is M10-1.0. The banjo bolt inlet has an M10-1.0 x 23.4 port thread.
How do I spot a leaking rear right caliper?
Fluid around the caliper or its dust boot, or uneven pad wear seen during a brake service, can point to a leak or a sticking caliper. A shop can test it.
