Nugeon 99-01751A rear left brake caliper for the 2014-2015 Lexus IS250 clamps the pads against the rotor to slow the wheel. This remanufactured Nugeon brake caliper replaces a worn or leaking one at the rear left wheel.
A sticking or leaking disc brake caliper can show up as the car pulling to one side, brake fluid around the wheel or uneven pad wear. Before you replace this caliper, rule out worn pads, a damaged brake hose and sticking slides, since those can produce similar signs.
This rear brake caliper is a direct-fit replacement for the 2014-2015 Lexus IS250. This listing is one caliper for the rear left; the rear right takes its own, and the pair on that axle is normally done at the same time.
Fit and size
Build and materials
One remanufactured rear left caliper with its mounting bracket, caliper slides, dust boots, caliper and pad hardware, bleeder screw with cap and crush washers. This listing holds one caliper, and the rear left side takes one; the rear right is ordered separately. Brake pads, anti-squeal shims, wear sensors, the bracket mounting bolts and the mounting bolt are not included, so plan on new bolts.
Interchange / FMSI:
FMSI: D1391
Product information is for general reference and may contain errors. See our Disclaimer.
Is the Nugeon 99-01751A the correct rear caliper for the left side of a 2014-2015 Lexus IS250?
Yes. Nugeon 99-01751A is the rear left caliper for the 2014-2015 Lexus IS250. The rear right side is a separate part.
Does the Nugeon caliper come with pads and the bracket bolts?
No. The bracket, slides, dust boots and hardware are included; pads, anti-squeal shims, wear sensors and the bracket mounting bolts are not, so plan on new bolts.
What thread does the inlet fitting on the Nugeon 99-01751A use?
The Nugeon 99-01751A has a banjo bolt inlet fitting with an M10 - 1.0 thread. Crush washers are included.
How can I tell if a rear brake caliper is sticking?
The car pulling to one side, a burning smell after a drive or brake fluid around the wheel can mean a caliper problem. A shop can confirm it.
What kind of piston does this floating caliper have?
This caliper has one steel piston that is 41 mm (1.61 in) in outside diameter, in a floating design.
No reviews yet — be the first to review this product.
Write a Review
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.