Nugeon Disc Brake Caliper P/N:99-00848A
Nugeon 99-02116A rear right brake caliper for the 2000-2005 Volkswagen Passat and other vehicles clamps the brake pads against the rotor to slow the wheel. This remanufactured disc brake caliper is a floating design with a single piston.
A sticking or leaking caliper can show up as the car pulling to one side under braking, a burning smell at one wheel or fluid around the brake. Before replacing it, look over the dust boot and hose connection for wet fluid with the engine off, and leave any pressure test to a shop.
This is a rear brake caliper for the 2000-2005 VW Passat, and it also fits the 2001-2005 Audi Allroad Quattro and the 1998-2004 Audi A6 Quattro. This listing is one caliper for the rear right; the rear left is a separate part, and the other side of that axle is normally done at the same time.
Fit and size
Build and materials
One caliper with its bracket, slides, dust boots, bleeder screw, caliper and pad hardware, banjo bolt and crush washers. Brake pads, anti-squeal shims, wear sensors, the bleeder screw cap and the bracket mounting bolts are not included, so plan on new bolts rather than reusing the old ones. This listing holds one caliper, and the rear right position takes one.
Product information is for general reference and may contain errors. See our Disclaimer.
Does this brake caliper fit the 2001-2005 Audi Allroad Quattro?
Yes. Nugeon 99-02116A is a rear right caliper listed for the 2001-2005 Audi Allroad Quattro and the 1998-2004 Audi A6 Quattro, as well as the 2000-2005 Volkswagen Passat.
Is this the rear caliper for the right side of the 2000-2005 VW Passat?
Yes. Nugeon 99-02116A is the rear right caliper for the 2000-2005 VW Passat. The rear left side takes its own caliper.
Is this Nugeon brake caliper remanufactured?
Yes. This caliper is remanufactured and has a rust preventative finish on an aluminum casting with a steel piston.
Do I get brake pads with the Nugeon caliper?
No. Pads, anti-squeal shims, wear sensors and the bracket mounting bolts are not included. The caliper does come with its bracket, slides, dust boots and bleeder screw.
What thread sizes does this rear right caliper use?
The banjo inlet thread is M12-1.0 and the bleeder screw thread is M10-1.0. The single steel piston measures 38.07 mm across.
No reviews yet — be the first to review this product.
Write a Review
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.