Nugeon Disc Brake Caliper P/N:99-01403B
Nugeon 99-17954A front right brake caliper for the 2005-2008 Ford F-150 and other vehicles is a remanufactured floating caliper that clamps the pads onto the rotor.
Pulling to one side, a brake that drags or fluid around the dust boot can mean a caliper problem, but a brake hose or the pads may be behind them. During a brake service, look at the dust boot, slides and pad wear with the engine off, and find the cause before replacing the caliper.
This caliper fits the 2005-2008 Ford F-150 and the 2006-2008 Lincoln Mark LT. This listing is one caliper for the front right; the front left is a separate part, and the other side of the axle is normally done at the same time.
Fit and size
Build and materials
One front right caliper with its mounting bracket, slides, dust boots, caliper and pad hardware, bleeder screw, banjo bolt and crush washers. The front right takes one caliper. Pads, bracket mounting bolts, the mounting bolt, anti-squeal shims, wear sensors and the bleeder screw cap are not included, so plan on new bolts rather than reusing the old ones.
Product information is for general reference and may contain errors. See our Disclaimer.
Is the Nugeon 99-17954A the right Ford F-150 brake caliper for a 2005-2008 truck?
Yes. Nugeon 99-17954A is a front right caliper that fits the 2005-2008 Ford F-150, and the 2006-2008 Lincoln Mark LT also takes it.
Does this Nugeon caliper come with the bracket and brake pads?
Yes for the bracket, which comes with slides, dust boots and hardware; no for brake pads. Wear sensors, anti-squeal shims and bracket mounting bolts are not included either.
What kind of Nugeon brake caliper is this, and how big are its pistons?
Nugeon 99-17954A is a floating caliper with two phenolic pistons, each 54 mm (2.126 in) in diameter.
How can I tell if a disc brake caliper is leaking or wearing the pads unevenly?
During a brake service, look for fluid around the dust boot or pads worn unevenly side to side. A pull to one side when braking can also be a sign, and a shop can test the rest.
What thread sizes does the inlet and bleeder screw use on this caliper?
The banjo bolt inlet uses a 3/8-24 thread, and the bleeder screw is M10-1.0. Nugeon 99-17954A includes both the banjo bolt and the bleeder screw.
No reviews yet — be the first to review this product.
Write a Review
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.