Nugeon Disc Brake Caliper P/N:97R17400A
TERREPOWER 99P00549A rear right brake caliper for the 1995-2001 Nissan Maxima and other vehicles clamps the brake pads against the rotor to slow the wheel. This unit is remanufactured and replaces a worn or leaking caliper on that side of the car.
A sticking slide, a worn rotor or worn pads can be behind a pull to one side, uneven pad wear or a burning smell, so find the cause before you buy a caliper. If a seized piston or a fluid leak at the caliper is the cause, this one replaces it.
This is a rear right brake caliper for the 1995-2001 Nissan Maxima and the 1996-2001 Infiniti I30. This listing is one caliper; the left side of that axle is a separate part and is normally done at the same time.
Fit and size
Build and materials
One rear right caliper; the car takes one on this side. It comes with the mounting bracket, caliper slides, dust boots, caliper and pad hardware, a bleeder screw with its cap, and crush washers. Pads, anti-squeal shims, wear sensors and bracket mounting bolts are not included, so plan on new bolts rather than reusing the old ones.
Interchange / FMSI:
FMSI: D540
Product information is for general reference and may contain errors. See our Disclaimer.
Does the TERREPOWER 99P00549A fit the rear right of a 1995-2001 Nissan Maxima?
Yes. TERREPOWER 99P00549A is a rear right brake caliper for the 1995-2001 Nissan Maxima, and it also fits the 1996-2001 Infiniti I30.
Is this disc brake caliper sold with brake pads?
No. Pads, anti-squeal shims and wear sensors are not included. It does come with its bracket, slides, dust boots, pad hardware and a bleeder screw.
How big is the piston on this rear caliper?
The piston is steel and 34 mm (1.34 in) across. This floating caliper has a single piston.
What would a sticking rear caliper feel like while driving?
A pull to one side, a burning smell after driving or one rear pad wearing faster than the other can be signs. Have the brakes inspected promptly if you notice any of them.
What thread does the bleeder screw on the TERREPOWER 99P00549A use?
The bleeder screw is M10-1.0 (3/8-24 in), and the inlet is a banjo bolt fitting with an M10 - 1.0 thread. A bleeder screw and its cap come with the caliper.
No reviews yet — be the first to review this product.
Write a Review
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.