TERREPOWER 99P01663B rear left brake caliper for the 2001-2003 Toyota Highlander clamps the brake pads against the rotor to slow the wheel. This remanufactured unit is made for the rear left side.
Signs that a disc brake caliper is sticking or leaking can include the vehicle pulling to one side, one pad wearing faster than the other, or brake fluid around the dust boot. Worn pads, a stiff slide or a brake hose can give similar symptoms, so during a brake service, with the engine off and the brakes cool, look over the pads and boot and find the cause before replacing the caliper.
Use it as a brake caliper replacement for the rear left of the 2001-2003 Toyota Highlander.
Fit and size
Build and materials
One rear left caliper with its mounting bracket, caliper slides, dust boots, caliper and pad hardware, bleeder screw, one banjo bolt and crush washers. Brake pads, bracket mounting bolts, anti-squeal shims, wear sensors and the bleeder screw cap are not included, and the old mounting bolts may not be reusable, so plan on new ones. This listing is one caliper for the rear left, which takes one; the rear right is a separate part, and both sides are normally replaced together.
Is the TERREPOWER 99P01663B caliper right for the 2001-2003 Toyota Highlander?
Yes. The TERREPOWER 99P01663B is the rear left caliper for the 2001-2003 Toyota Highlander. The rear right side is a separate part.
Does this rear left caliper come with the bracket and slides?
Yes. The bracket, caliper slides, dust boots, hardware, bleeder screw and banjo bolt with crush washers are included. Brake pads, bracket mounting bolts and anti-squeal shims are not.
What piston size does this caliper have?
TERREPOWER 99P01663B has one steel piston with a 38.02 mm (1.5 in) outside diameter, in a floating cast iron caliper.
Why would one rear wheel drag or the car pull to one side?
A caliper that does not release can make a wheel drag, run hot or pull the car to one side. Brakes are a safety item, so have them inspected promptly.
What thread sizes does this caliper use for the bleeder and the brake line?
The included bleeder screw is M7-1.0, and the banjo inlet port is M10-1.0 x 23.4. The bleeder screw cap is not included.
No reviews yet — be the first to review this product.
Write a Review
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
