TERREPOWER 99P01706B front right brake caliper for the 2011-2018 Toyota RAV4 and other vehicles presses the brake pads against the rotor to slow the wheel. It is a remanufactured disc brake caliper that includes its bracket.
A caliper that is failing can show as fluid around the dust boot, a pad worn more on one end, or the car pulling to one side under braking. Before you replace the caliper, rule out worn pads, a stuck slide and a damaged brake hose, since any of them can look much the same from the driver's seat.
This caliper is listed for a wide range of Toyota, Scion and Lexus models, such as the 2011-2018 Toyota RAV4, the 2012-2018 Toyota Prius v and the 2008-2015 Scion xB. Open the "Vehicles it fits" section to check your exact model and engine.
Fit and size
Build and materials
One front right caliper with its mounting bracket, caliper slides, dust boots, caliper and pad hardware, bleeder screw and crush washer. Brake pads, wear sensors, anti-squeal shims, the bracket mounting bolts, the mounting bolt and the bleeder screw cap are not included, so plan on new bolts rather than reusing the old ones. This listing holds one caliper and the front right takes one; the front left is a separate part ordered on its own, and the two are normally replaced together.
Interchange / FMSI:
FMSI: D1210
Is this a 2011-2018 Toyota RAV4 brake caliper that fits the L4-2.5L engine?
Yes. TERREPOWER 99P01706B, the front right caliper, is listed for the 2011-2018 Toyota RAV4, including the L4-2.5L engine.
Is this a 2008-2015 Scion xB brake caliper for the front right wheel?
Yes. The 2008-2015 Scion xB is listed for this front right caliper, and the left side takes its own caliper. Open the "Vehicles it fits" section to check another model.
Do brake pads come with the TERREPOWER 99P01706B caliper?
No. The caliper comes with its bracket, slides, dust boots, hardware, bleeder screw and crush washer. Pads, wear sensors, anti-squeal shims and mounting bolts are not included.
Is this remanufactured caliper a floating or fixed design?
TERREPOWER 99P01706B is a floating caliper with one steel piston. The piston outside diameter is 63.37 mm (2.5 in), and the caliper is cast iron.
What thread sizes does this front right caliper use for the brake line and bleeder?
The banjo inlet fitting has an M10-1.0 thread, and the bleeder screw is M7-1.0. A crush washer is included; the bleeder screw cap is not.
No reviews yet — be the first to review this product.
Write a Review
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
