TERREPOWER 99P01724A rear right brake caliper for the 2010-2015 Toyota Prius and other vehicles clamps the brake pads against the rotor to slow the wheel. This remanufactured disc brake caliper replaces the unit on the rear right wheel.
A failing caliper can show up as the car pulling to one side under braking, brake fluid around the caliper or its dust boot, or one rear pad wearing faster than the other. Worn pads, a worn rotor or a stuck slide can be behind those signs too, so find the cause before buying a caliper.
This caliper is a direct-fit replacement for the 2010-2015 Toyota Prius and the 2012-2015 Toyota Prius Plug-In. There is one caliper on each side of the rear axle. This listing is the rear right one, the rear left is a separate part ordered on its own, and the two are normally replaced together.
Fit and size
Build and materials
One remanufactured caliper with its mounting bracket, caliper slides, dust boots, caliper and pad hardware, bleeder screw with cap, banjo bolt and crush washer. Brake pads, anti-squeal shims, wear sensors and the bracket and caliper mounting bolts are not included; plan on new bolts, since the old ones may not be reusable.
Interchange / FMSI:
FMSI: D1423E
Will this rear right 2010-2015 Toyota Prius brake caliper also fit the 2012-2015 Toyota Prius Plug-In?
Yes. TERREPOWER 99P01724A fits the 2012-2015 Toyota Prius Plug-In as well as the 2010-2015 Toyota Prius, and it is made for the rear right wheel.
Does the TERREPOWER 99P01724A come with the bleeder screw and bracket?
Yes. TERREPOWER 99P01724A includes the bleeder screw with cap, the mounting bracket, slides, dust boots and hardware. Brake pads, anti-squeal shims, wear sensors and mounting bolts are not included.
What thread size does this caliper's brake line inlet use?
The banjo bolt inlet port is M10-1.0 x 23.4 mm, and the bleeder screw is M10-1.0. One banjo bolt and a crush washer come with the caliper.
How can I tell if a rear caliper is sticking or leaking?
Signs can include fluid at the caliper or its dust boot, the car pulling to one side when braking, or one rear pad wearing faster than the other. A shop can confirm the cause.
What cast numbers does this remanufactured caliper carry?
The housing cast number is TOKICO 1B and the bracket cast number is T HI TR TM. You can compare them with the numbers on your old caliper.
No reviews yet — be the first to review this product.
Write a Review
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
