Nugeon Disc Brake Caliper P/N:97R17400A
TERREPOWER 99P03383A rear left brake caliper for the 2014-2021 Volkswagen Passat and other vehicles clamps the pads against the rotor to slow the wheel. This remanufactured disc brake caliper turns brake fluid pressure into clamping force at the wheel.
A pull to one side under braking or brake fluid around the caliper can mean this caliper is worn or sticking, though a worn brake hose or worn pads can sit behind the same signs, so find the cause before you replace it.
This rear left caliper suits the 2014-2021 Volkswagen Passat, the 2015-2017 Volkswagen Golf and the 2015-2017 Volkswagen Golf SportWagen, along with other models. If your car is not named here, look for it in the "Vehicles it fits" section. The listing is one caliper for the left side; the axle takes one caliper per side, so the rear right is ordered separately, and the two are normally replaced together.
Fit and size
Build and materials
One brake caliper with its mounting bracket, caliper slides, dust boots, bleeder screw, caliper and pad hardware and crush washers. Brake pads, anti-squeal shims, wear sensors, a bleeder screw cap, a grease pack and the bracket mounting bolts are not included, so plan on new mounting bolts rather than reusing the old ones.
Interchange / FMSI:
FMSI: D1779
Product information is for general reference and may contain errors. See our Disclaimer.
Is this a VW Passat rear brake caliper for 2014-2021 cars?
Yes, TERREPOWER 99P03383A is a rear left brake caliper for the 2014-2021 Volkswagen Passat. If your car is a different model, look for it in the "Vehicles it fits" section.
Is this a Golf brake caliper for the 2015-2017 model years?
Yes, TERREPOWER 99P03383A fits the 2015-2017 Volkswagen Golf on the rear left. The rear right takes its own caliper, which is a separate part.
Does this caliper come with the bracket and bleeder screw?
Yes, this caliper comes with the mounting bracket, slides, dust boots, bleeder screw, caliper and pad hardware and crush washers. Pads, wear sensors, shims and bracket mounting bolts are not included.
What size is the piston on this rear left caliper?
The single steel piston is 38.07 mm (1.5 in) in diameter. The bleeder screw thread is M10-1.0, and the banjo inlet uses an M10-1.5 thread.
What cast numbers are on the housing and bracket of this caliper?
The housing carries cast number 4200 38 2785 and the bracket carries 9889 4202. The housing is cast iron with an E-coated finish.
No reviews yet — be the first to review this product.
Write a Review
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.