TERREPOWER 99P17761A front brake caliper for the 2012-2023 Dodge Charger and other vehicles clamps the pads onto the rotor to slow the wheel. This is a remanufactured caliper for either front wheel.
- Floating caliper with a single 60 mm phenolic piston
- Aluminum caliper casting with an E-coated finish
- Banjo-bolt inlet and bleeder screw both use an M10-1.5 thread
- Housing cast number K246-059C and bracket cast number 247C
Quick facts
- Part: TERREPOWER 99P17761A brake caliper
- Also called: disc brake caliper
- Fits: 2012-2023 Dodge Charger and other vehicles
- Position: Front right, front left
- Material: Aluminum
- Condition: Remanufactured
A sticking or leaking caliper can show up as the car pulling to one side under braking, pads that wear faster on one wheel, or brake fluid around the dust boot. A pull alone does not prove the caliper is at fault, since a collapsed brake hose is another common source, so find the cause before replacing it.
Fits
This brake caliper is a direct-fit replacement for the 2012-2023 Dodge Charger, the 2012-2023 Chrysler 300 and the 2012-2023 Dodge Challenger, on either front side.
Specifications
Fit and size
- Position: front left and front right
- Quantity per application: 1
- Piston: 1, outside diameter 60 mm (2.36 in)
Build and materials
- Caliper type: floating
- Casting material: aluminum
- Piston material: phenolic
- Finish: E-coated
- Condition: remanufactured
- Country of origin: Mexico
In the box
One caliper with its mounting bracket, caliper slides, dust boots, caliper and pad hardware, bleeder screw with cap and crush washers. Brake pads, anti-squeal shims, wear sensors and the bracket mounting bolts are not included, so plan on new bolts because the old ones may not be reusable. This listing holds one caliper and each front wheel takes one, so order two for a front pair and fit them together.
Interchange / FMSI:
FMSI: D1056
Frequently Asked Questions
Is this the right brake caliper for the 2012-2023 Dodge Challenger?
Yes. TERREPOWER 99P17761A fits the 2012-2023 Dodge Challenger on either the front left or front right, and each of those wheels takes one caliper.
Does this disc brake caliper come with brake pads?
No. Pads, anti-squeal shims and wear sensors are not included. The bracket, slides, dust boots, hardware, crush washers and bleeder screw with cap are.
What size is the piston on the TERREPOWER 99P17761A?
This floating caliper has one phenolic piston with a 60 mm (2.36 in) outside diameter.
How can I tell if this front brake caliper is sticking?
The car can pull to one side when braking, the pads on one wheel can wear faster than the other, or fluid can show around the dust boot. A shop can test it properly.
What thread does the bleeder screw on this front brake caliper use?
The bleeder screw on TERREPOWER 99P17761A is M10-1.5, and the banjo-bolt inlet uses the same M10-1.5 thread.
