PowerStop Disc Brake Caliper P/N:L2796
PowerStop L2838 rear right brake caliper for the 2001-2005 Lexus IS300 clamps the brake pads against the rotor to slow the wheel. Autospecialty by PowerStop brake calipers bolt on directly in place of the original stock caliper.
A disc brake caliper that sticks or leaks can show up as the car pulling to one side, a burning smell after a drive, or brake fluid around the wheel. These signs alone do not prove the caliper is at fault, because a collapsed brake hose can also produce a pull.
This 2001-2005 Lexus IS300 brake caliper is a direct-fit replacement for the rear right position. The rear axle takes one caliper on each side; this listing is the right one, the rear left is a separate part, and the pair is normally done at the same time.
Fit and size
Build and materials
One brake caliper assembled with new seals, dust boots and bleeder screws. The mounting bracket, mounting hardware, caliper slides, brake pads, mounting bolts, caliper grease and pad wear sensor are not included, and the old mounting bolts may not be reusable, so plan on new ones.
Product information is for general reference and may contain errors. See our Disclaimer.
Is this the 2001-2005 Lexus IS300 rear caliper for the right side?
Yes. PowerStop L2838 is a rear right brake caliper for the 2001-2005 Lexus IS300. The rear left side takes its own caliper, ordered separately.
Does the PowerStop L2838 come with brake pads or a mounting bracket?
No. This rear right caliper comes with new seals, dust boots and bleeder screws. The bracket, mounting hardware, caliper slides, pads and mounting bolts are not included.
How many pistons does the PowerStop L2838 have?
The PowerStop L2838 is a fixed caliper with two steel pistons. The piston diameter is 40.36 mm.
What can a leaking or sticking rear brake caliper look like?
Brake fluid around the caliper or wheel, a car that pulls to one side, or uneven pad wear seen during a brake service can all be signs. A brake shop can test the caliper, and brake problems should be checked promptly.
What are the dust boots on this PowerStop caliper made of?
The dust boots are high temperature EPDM rubber. This caliper is also 100% pressure tested and inspected.
No reviews yet — be the first to review this product.
Write a Review
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.