PowerStop Disc Brake Rotor Set P/N:AR8655XPR
PowerStop AR8649XPR front brake rotor set for the 2002-2005 Chevrolet Trailblazer and other vehicles gives the pads a drilled and slotted face to clamp when you brake. Also called a disc brake rotor set, this PowerStop brake rotor pair is a bolt-on upgrade for stock brakes with no modifications necessary.
A pulse in the pedal, a shudder under braking, or grooves and cracks on the rotor face can mean worn rotors, but worn pads or a sticking caliper can show similar signs. Find the cause first: during a brake service, look over the old rotors and measure their thickness with the engine off. The 2002-2005 Chevrolet Trailblazer takes one set.
With a direct OE fit, no special modifications are needed, and weight and vane count match the original equipment design. These rotors are listed for a wide range of Chevrolet, Buick, GMC, Oldsmobile and Isuzu models, including the 2004-2005 Buick Rainier and the 2004-2005 Isuzu Ascender. If your vehicle is not named here, look it up in the "Vehicles it fits" section.
Fit and size
Build and materials
One pair of front brake rotors.
Product information is for general reference and may contain errors. See our Disclaimer.
Do these Trailblazer brake rotors fit the 2002-2005 Chevrolet Trailblazer front axle?
Yes, PowerStop AR8649XPR is a front rotor pair for the 2002-2005 Chevrolet Trailblazer, and owners of other vehicles can look theirs up in the "Vehicles it fits" section.
Do these PowerStop front rotors come with the ABS tone ring?
No, the ABS tone ring is not included with PowerStop AR8649XPR; this listing is the pair of front rotors only.
What do the drilled holes do on these PowerStop slotted rotors?
The cross-drilled holes are for brake cooling, and the rounded slots sweep away gases, dust and water. The drill holes are chamfered and the slots rounded to minimize stress cracking.
What is the minimum thickness for the PowerStop AR8649XPR rotors?
Nominal thickness is 29.00 mm (1.14 in) and discard thickness is 27.50 mm. Measure during a brake service with the engine off; a rotor at or below 27.50 mm needs replacing.
Are these brake rotors vented or solid, and what diameter are they?
Each rotor is vented and full cast, with a 305.00 mm outside diameter. The bolt circle is 127.00 mm (5.00 in) with 6 lug holes.
No reviews yet — be the first to review this product.
Write a Review
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.