SKF Engine Crankshaft Repair Sleeve 99354
SKF Engine Crankshaft Repair Sleeve 99354 - view 2
SKF Engine Crankshaft Repair Sleeve 99354
SKF Engine Crankshaft Repair Sleeve 99354 - view 2

SKF Engine Crankshaft Repair Sleeve P/N:99354

Be the first to review this product
$47.99
MPN: 99354
Item Package Quantity: 1
Adding to cart… The item has been added

Have questions?

Ask an Expert
SKF Engine Crankshaft Repair Sleeve P/N:99354
SKF Engine Crankshaft Repair Sleeve P/N:99354
$47.99

Refinish a scored or grooved crankshaft sealing surface without regrinding or pulling the shaft with the SKF Speedi Sleeve 99354, a thin-wall engine crankshaft repair sleeve that presses over a worn 3.543 in shaft to give the seal lip a fresh, precision outer sealing surface.

  • Fast shaft refinishing: installs over the shaft in place — no need to remove the shaft, and no change in seal size required.
  • AISI 304 stainless steel: engineered from AISI 304 stainless steel for a smooth, hard-wearing sealing surface.
  • Installation tool included: each Speedi Sleeve ships with an installation tool to help seat it squarely for proper results.
  • Sized to fit: 3.543 in shaft diameter, 0.906 in width.

When a seal starts leaking because the shaft's sealing surface has been scored or worn by the old seal lip, this sleeve provides a like-new surface for the seal to ride on. If a worn shaft surface is the cause of the leak, the Speedi Sleeve addresses it in minutes instead of a lengthy regrind. Sold as a shaft-size-specific sleeve — match the sleeve to your shaft diameter.

Interchange: 99354.1 · CHR 99354
993541 · CHR99354 · 207059841 · 975999354 · 145899354 · 6353826 · 99354CHR · N99354 · 100388414 · 99354RS

This part cross-references / interchanges with the following part numbers:

99354.1, 207059841, 99354, 975999354, CHR 99354, 145899354, 6353826, 99354CHR, N99354, 100388414, 99354RS

Frequently Asked Questions

What does the SKF 99354 Speedi Sleeve do?

It's a thin stainless steel repair sleeve that presses over a worn or scored shaft to provide a fresh outer sealing surface for the seal lip, so you don't have to regrind the shaft.

Do I have to remove the shaft to install it?

No. The Speedi Sleeve is designed to install over the shaft in place, without removing it, and it requires no change in seal size.

What shaft size does this sleeve fit?

The 99354 is sized for a 3.543 in shaft diameter and is 0.906 in wide. Match the sleeve to your shaft's diameter before ordering.

Is an installation tool included?

Yes. Each SKF Speedi Sleeve comes with an installation tool to help seat the sleeve squarely for proper results.

What is the sleeve made of?

It is engineered from AISI 304 stainless steel, which provides a smooth, hard-wearing outer surface for the seal lip to ride against.

Related Products

!