Steer with tight, predictable response using the SKP Rack and Pinion Assembly SK262754, a direct-fit replacement for the 2009-2015 Honda Pilot. It replaces the steering gear that converts rotation of the steering wheel into the side-to-side motion that moves the tie rods and turns the front wheels.
- Complete assembly: supplied as a rack and pinion unit to replace the worn or leaking original on the listed application.
- Steering function: translates steering-wheel input into linear rack travel for controlled front-wheel steering.
- Application-matched: a direct-fit replacement for the 2009-2015 Honda Pilot listed below.
Signs this part may need replacing include steering fluid leaks, a loose or wandering feel, hard or uneven steering effort, clunking through the steering, or uneven front tire wear. Because these symptoms can have other causes, diagnose the steering system before ordering; if a failed rack and pinion is the cause, this assembly replaces it. After installation, an alignment is typically required to reset toe. Full fitment appears below and on the Buyer's Guide tab.
Interchange: 305-0187 · 3050187 · N305-0187 · N3050187
Manufacturer part number SK262754
This part cross-references / interchanges with the following part numbers:
Frequently Asked Questions
What vehicle does this rack and pinion assembly fit?
It is a direct-fit replacement for the 2009-2015 Honda Pilot. Check the Buyer's Guide tab to confirm fitment for your specific vehicle.
What does a rack and pinion assembly do?
It converts the rotation of your steering wheel into linear motion that moves the tie rods, turning the front wheels left and right.
What are signs my rack and pinion may need replacing?
Common signs include steering fluid leaks, a loose or wandering feel, hard or uneven steering effort, clunking, or uneven front tire wear. Diagnose the cause before replacing.
What interchange numbers does this part cross-reference?
It replaces interchange numbers 305-0187 (3050187) and N305-0187 (N3050187). Its own manufacturer part number is SK262754.
Do I need an alignment after installing this part?
Yes, a wheel alignment is typically required after replacing a rack and pinion assembly to reset toe and ensure proper steering and even tire wear.
Write a Review