Stabilus Hood Lift Support P/N:3B-919219
Keep the hood of your 2009-2016 Lincoln MKS propped open smoothly with the Stabilus Hood Lift Support 3B-399852, a gas-charged lift support built with the Lift-O-Mat dynamic damping system. It uses a longitudinal groove (a velocity manifold) pressed into the tube wall so gas flows around the piston at an extension speed engineered for this application, and the groove narrows toward the end of the stroke for a gentle, controlled stop.
For best results, replace in pairs so both sides support the hood evenly.
Interchange: 8A5Z 16C826-A · 8A5Z 16C826-B · DA5Z 16C826-A · DA5Z 16C826-B
C96562DL · 86562 · 8A5Z16C826A · 8A5Z16C826B · DA5Z16C826A · DA5Z16C826B · C96562 · 399852 · 6562 · C6562 · 611016 · SG204071 · TSG204071
This part cross-references / interchanges with the following part numbers:
What vehicle does this hood lift support fit?
It is a direct-fit replacement for the 2009-2016 Lincoln MKS. Check the Buyer's Guide tab to confirm the application for your specific vehicle.
What is Lift-O-Mat dynamic damping?
A velocity-manifold groove pressed into the tube wall lets gas flow around the piston at an engineered extension speed, creating a fluid opening motion with no bouncing or jerking during cycling.
Should I replace both hood lift supports at once?
For best results, Stabilus recommends replacing them in pairs so both sides support the hood evenly and open with matched motion.
Does it resist corrosion?
Yes. The part coatings are tested to automotive standards for corrosion resistance.
How long is this lift support and is it hard to install?
It measures 24.02 inch. It is easy to install and requires no special tools.
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.