Stabilus Hood Lift Support P/N:3B-218477
Hold the hood up with a smooth, controlled motion using the Stabilus Hood Lift Support 3B-932856, a gas-charged lift support that drops in as a direct-fit replacement for the 2015-2019 Lincoln MKC (see the "Vehicles it fits" section for engine details). This 24.41-inch Lift-O-Mat unit uses dynamic damping speed control to raise and support the hood without bouncing or jerking during cycling.
Lift supports work as a pair, so for best results Stabilus recommends replacing both sides together. If a weak or leaking original support is why your hood drifts down or won't stay up, this replaces it.
Interchange: EJ7Z 16C826-A
EJ7Z16C826A · 932856 · 7298 · D7298
Product information is for general reference and may contain errors. See our Disclaimer.
This part cross-references / interchanges with the following part numbers:
What vehicle does this hood lift support fit?
It is a direct-fit replacement for the 2015-2019 Lincoln MKC. Check the "Vehicles it fits" section to confirm it matches your specific vehicle.
How long is this lift support?
It measures 24.41 inches, matching the OE design for the listed Lincoln MKC application.
Should I replace both lift supports at once?
Stabilus recommends replacing them in pairs for best results, since both sides typically wear at a similar rate for balanced, even support.
What is dynamic damping?
A longitudinal groove pressed into the tube wall lets gas flow around the piston, controlling extension speed for a fluid opening motion and a gentle stop without bouncing or jerking.
Do I need special tools to install it?
No. Stabilus states this lift support is easy to install and requires no special tools.
No reviews yet — be the first to review this product.
Write a Review
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.