Hold the hood up with a smooth, controlled motion using the Stabilus Hood Lift Support 4B-437849, a 21.12-inch gas-charged lift support with dynamic speed control. Based on the OE design for proper fit, form and function, it installs on the 2006-2013 Chevrolet Impala, 2014-2016 Chevrolet Impala Limited, and 2006-2007 Chevrolet Monte Carlo.
- Dynamic damping speed control: creates a fluid opening motion with no bouncing or jerking during cycling.
- Lift-O-Mat by Stabilus: a longitudinal velocity-manifold groove pressed into the tube wall lets gas flow around the piston, with the groove narrowing toward the end of the stroke for a gentle, controlled stop.
- Corrosion-tested coatings: part coatings tested to automotive standards for corrosion resistance.
- Easy installation: requires no special tools; for best results replace in pairs.
Over time a gas lift support can lose charge, letting the hood drift down, feel weak, or drop faster than it should. If a worn support is the cause, this Stabilus unit restores firm, damped hood movement. Because it operates as one of a pair, replacing both sides together helps keep the hood balanced and even.
Interchange: 819-6551 · 819-8118
10330397 · 15833919 · C95651DL · 84582 · C95651 · 8196551 · 8198118 · 025853 · 1861UE · 437610 · 437849 · 4568TY · 7135UD · 9731VP · 9735VW · 4582 · C4582 · 611991 · SG330085 · SG330087 · TSG330085 · TSG330087
Product information is for general reference and may contain errors. See our Disclaimer.
This part cross-references / interchanges with the following part numbers:
LS10223, 10330397, 15833919, C95651DL, 84582, 4582, C4582, C95651, 819-6551, 8196551, 819-8118, 8198118, 025853, 1861UE, 437610, 437849, 4568TY, 7135UD, 9731VP, 9735VW, 611991, SG330085, SG330087, TSG330085, TSG330087
Frequently Asked Questions
What vehicles does the Stabilus 4B-437849 hood lift support fit?
It fits the 2006-2013 Chevrolet Impala, 2014-2016 Chevrolet Impala Limited, and 2006-2007 Chevrolet Monte Carlo. Check the "Vehicles it fits" section to confirm the fit for your vehicle.
What does this hood lift support do?
It is a gas-charged lift support with dynamic speed control that helps raise and hold the hood open with a fluid, damped motion, without bouncing or jerking during cycling.
How long is this lift support?
The manufacturer lists this Stabilus lift support at 21.12 inches.
Should I replace both hood lift supports at once?
Stabilus recommends replacing in pairs for best results, since both supports typically wear at a similar rate and matched pairs keep the hood balanced.
How does the Lift-O-Mat dynamic damping work?
A longitudinal velocity-manifold groove pressed into the tube wall lets gas flow around the piston, and the groove narrows toward the end of the stroke for a gentle, controlled stop.
