Raise your hood smoothly and hold it steady with the Stabilus Hood Lift Support 4B-755526. This gas-charged lift support drops in as a direct-fit replacement for the 2014-2019 Cadillac CTS; see the Buyer's Guide tab for engine-level fitment details.
Built around Stabilus' Lift-O-Mat design, it uses a longitudinal groove (a velocity manifold) pressed into the tube wall so gas flows around the piston with extension speed and damping engineered for this application, and the groove narrows toward the end of the stroke for a gentle, controlled stop.
For best results, replace supports in pairs. If a weak or leaking lift support is the cause of a hood that won't stay up or drops on its own, this replaces it.
Interchange: 22784840 · D97025DL · 87025 · D97025 · 590815 · 755526 · 887656 · 7025 · D7025 · 613476
This part cross-references / interchanges with the following part numbers:
What vehicle does this hood lift support fit?
It is a direct-fit replacement for the 2014-2019 Cadillac CTS. Check the Buyer's Guide tab to confirm the fit for your specific vehicle and engine.
What does a hood lift support do?
It is a gas-charged strut that raises the hood and holds it open. When it weakens or leaks, the hood may not stay up or may drop on its own.
Should I replace both lift supports at once?
For best results, Stabilus recommends replacing them in pairs so both sides open and hold with consistent, balanced motion.
What is Lift-O-Mat dynamic damping?
It uses a groove pressed into the tube wall so gas flows around the piston with tuned extension speed and damping, giving a fluid opening motion and a gentle, controlled stop.
Are special tools required to install it?
No. It is based on the OE design for proper fit, form and function and is easy to install with no special tools required.
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
