Hood Lift Support for 2003-2007 Honda Accord - Stabilus 4B-9904VE

$20.99
WARNING:California Proposition 65▾

Vehicles this part fits

    Part number: 4B-9904VE
    UPC: 194879009834
    Condition: New
    Weight: 1.40 LBS
    Item Package Code: EA
    Part Has Core (Y/N): N
    Item Package Quantity: 1
    $20.99
    Adding to cart… The item has been added

    Have questions?

    Stabilus Hood Lift Support P/N:4B-9904VE
    Stabilus Hood Lift Support P/N:4B-9904VE
    $20.99
    $20.99

    Hold your hood open smoothly and keep it from drifting down with the Stabilus Hood Lift Support 4B-9904VE, a 16.57-inch gas-charged strut with dynamic speed control. It installs as a direct-fit replacement for the 2003-2007 Honda Accord — see the "Vehicles it fits" section for engine-level details on the listed applications.

    • Dynamic damping: Stabilus Lift-O-Mat uses a longitudinal groove (velocity manifold) pressed into the tube wall, letting gas flow around the piston for a fluid opening motion with no bouncing or jerking during cycling.
    • Gentle stop: the groove profile narrows toward the end of the stroke for a controlled, low-impact stop.
    • Corrosion resistance: part coatings are tested to automotive standards for corrosion resistance.
    • Easy install: based on the OE design for proper fit, form, and function, and requires no special tools.

    A tired hood support that slowly sags, feels weak in the cold, or lets the hood fall may be worn out; if the lift support is the cause, this unit replaces it. For balanced hood movement, Stabilus recommends replacing supports in pairs where the hood uses more than one.

    Product information is for general reference and may contain errors. See our Disclaimer.

    Frequently Asked Questions

    What vehicle does this hood lift support fit?

    It is a direct-fit replacement for the 2003-2007 Honda Accord. Check the "Vehicles it fits" section to confirm the fit for your specific vehicle.

    What is the length of this lift support?

    This Stabilus lift support measures 16.57 inches. It is a gas-charged unit with dynamic speed control.

    What does dynamic damping do?

    A groove pressed into the tube wall lets gas flow around the piston, creating a fluid opening motion with no bouncing or jerking and a gentle, controlled stop at the end of the stroke.

    Should I replace both supports at once?

    For best results and balanced hood movement, Stabilus recommends replacing supports in pairs on hoods that use more than one.

    Are any special tools needed to install it?

    No. It is based on the OE design for proper fit, form, and function and installs with common hand tools — no special tools required.

    Reviews

    No reviews yet — be the first to review this product.

    Write a Review