Keep your Cadillac's rear liftgate raised and moving smoothly with the Stabilus Liftgate Lift Support 3B-9015QW, a gas-charged lift support featuring Stabilus Lift-O-Mat dynamic speed control. It drops in as a direct-fit replacement for the 2002-2004 Cadillac Escalade, 2003-2004 Cadillac Escalade ESV, and 2002-2004 Cadillac Escalade EXT — see the "Vehicles it fits" section for full engine details. When a worn support can no longer hold the glass or hatch, the liftgate drifts down, opens slowly, or feels jerky; this replaces the original.
- Dynamic damping speed control: a longitudinal velocity-manifold groove pressed into the tube wall channels gas around the piston, creating a fluid opening motion with no bouncing or jerking during cycling.
- Gentle, controlled stop: the groove narrows toward the end of the stroke for a soft finish with minimal impact.
- Corrosion resistance: part coatings tested to automotive standards.
- Easy installation: based on the OE design for proper fit, form, and function, and requires no special tools.
For best results, replace lift supports in pairs so both sides hold and cycle evenly.
Interchange: 819-6034
15057528 · 15057529 · C95282DL · 86235 · C95282 · 901447 · 8196034 · 2076PO · 2082PB · 7647QW · 7648QR · 8266SA · 8271ST · 9015QW · 9951MZ · 9952MU · 4557 · 46235 · 6235 · C6235 · SG230045 · SG230046 · SG230057 · TSG230057
This part cross-references / interchanges with the following part numbers:
LS10393, 15057528, 15057529, C95282DL, 86235, 4557, 6235, C6235, C95282, 901447, 819-6034, 8196034, 2076PO, 2082PB, 7647QW, 7648QR, 8266SA, 8271ST, 9015QW, 9951MZ, 9952MU, 46235, SG230045, SG230046, SG230057, TSG230057
Frequently Asked Questions
What vehicles does the Stabilus 3B-9015QW fit?
It's a direct-fit replacement for the 2002-2004 Cadillac Escalade, 2003-2004 Cadillac Escalade ESV, and 2002-2004 Cadillac Escalade EXT. Check the "Vehicles it fits" section for full details.
What does this liftgate lift support do?
It's a gas-charged support that helps raise the liftgate and hold it open. Its Lift-O-Mat dynamic damping controls opening speed for a smooth motion and a gentle stop.
How do I know my lift support is failing?
Signs include a liftgate that drifts or drops down on its own, opens slowly, or feels jerky. If a worn support is the cause, replacing it addresses those symptoms.
Should I replace both lift supports at once?
Stabilus recommends replacing in pairs for best results, so both sides hold and cycle evenly. Confirm the quantity your vehicle uses before ordering.
Are special tools required to install it?
No. It's based on the OE design for proper fit, form, and function and is easy to install with no special tools required.
