Standard Ignition ABS Wheel Speed Sensor P/N:ALS2292
Standard Motor Products
Standard Ignition ALS1204 front right ABS wheel speed sensor for the 2002-2004 Dodge Intrepid and other vehicles reports wheel speed to the ABS. The ABS uses that signal to spot a wheel that is about to lock up.
A lit ABS or traction control warning light can point to a wheel speed sensor problem, and if this sensor is the cause, this one replaces it. Before you replace it, rule out a damaged wire, a loose connector or a dirty or damaged tone ring at the front right wheel, since those can set the same light.
Other vehicles it fits include the 2002-2004 Chrysler 300M and the 2002-2004 Chrysler Concorde, and the front right wheel takes one sensor on each. This listing is one sensor; the front left is a separate part on that axle. Look up your own car's year and model in the "Vehicles it fits" section.
Fit and size
Build and materials
One front right ABS wheel speed sensor with location grommets and wire clips on the harness. Mounting hardware is not included, so plan on new bolts, as the old ones may not be reusable.
Product information is for general reference and may contain errors. See our Disclaimer.
Is the Standard Ignition ALS1204 sensor right for a 2002-2004 Dodge Intrepid?
Yes, Standard Ignition ALS1204 is a front right ABS wheel speed sensor for the 2002-2004 Dodge Intrepid and also suits the 2002-2004 Chrysler 300M. Look up other cars in the "Vehicles it fits" section.
Does the ALS1204 ABS sensor come with grommets and clips?
Yes, the harness has location grommets and wire clips on it. Mounting hardware is not included, so plan on new bolts.
How long is the harness on this front right ABS speed sensor?
The Standard Ignition ALS1204 harness is 24.25 inches (610 mm) long. It ends in one oval connector with two male pin terminals.
Can a bad front right ABS speed sensor turn on the ABS light?
Yes, a sensor that fails to report wheel speed can light the ABS warning, and sometimes the traction control light. A shop can test the sensor and its wiring.
Is the connector on this Standard Ignition ABS sensor sealed?
Yes, the Standard Ignition ALS1204 uses a sealed connector to protect against harsh conditions.
No reviews yet — be the first to review this product.
Write a Review
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.