Standard Ignition ABS Wheel Speed Sensor P/N:ALS2087
Standard Motor Products
Standard Ignition ALS410 rear ABS wheel speed sensor for the 1994-1996 Mercedes-Benz C220 and other vehicles reports wheel speed to the ABS. Its signal helps the ABS and related safety systems track how fast the wheel at that corner is turning.
A lit ABS or traction control warning light can mean a wheel speed sensor has failed, though a damaged harness or tone ring can light it as well. Before replacing the sensor, look over the visible wiring and connector with the engine off for chafing or corrosion, and leave any check that needs the car lifted or running to a shop.
This rear ABS wheel speed sensor is engineered specifically for Mercedes-Benz vehicles and fits the 1994-1996 Mercedes-Benz C220, the 1996 Mercedes-Benz C230 and the 1994-1996 Mercedes-Benz C280. Those cars take two rear sensors, and this listing is one.
Fit and size
Build and materials
One ABS wheel speed sensor with its harness. Mounting hardware is not included, so plan on a new bolt, as the old one may not be reusable.
Interchange: ABS520 · ABSD30955 · 531087 · 2025400117
Product information is for general reference and may contain errors. See our Disclaimer.
This part cross-references / interchanges with the following part numbers:
Does the Standard Ignition ALS410 fit a 1996 Mercedes-Benz C230?
Yes. Standard Ignition ALS410 is a rear ABS wheel speed sensor listed for the 1996 Mercedes-Benz C230. If your car is another model, look for it in the "Vehicles it fits" section on this page.
Do I need to buy a bolt separately for this rear ABS wheel speed sensor?
Yes. Standard Ignition ALS410 does not include mounting hardware, so plan on a new bolt, since the old one may not be reusable. Grommets and wire clips are already on the harness.
How long is the harness on this ABS wheel speed sensor?
The harness is 18 inches (460 mm) long and ends in one rectangular female connector.
Can a bad wheel speed sensor turn on my ABS light?
Yes, a faulty wheel speed sensor can turn on the ABS or traction control light, but other faults can too. A shop can read the codes to see which wheel is reporting a problem.
Does Standard Ignition ALS410 replace ABS520?
Yes. ABS520 is listed as an interchange number for Standard Ignition ALS410, along with ABSD30955, 531087 and 2025400117.
No reviews yet — be the first to review this product.
Write a Review
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.