Carry a clean ABS wheel-speed signal from the sensor to your Lexus's control module with the Standard Ignition ABS Wheel Speed Sensor Wiring Harness (MPN ALH48). It installs to the vehicle's existing ABS speed sensor and wiring, and drops in as a direct-fit OE replacement for the front-left position on the 2007 and 2009 Lexus LS460 (All engines) — note these are two separate model years, not a continuous span.
This harness carries the wheel-speed signal only; if a damaged, corroded, or broken ABS harness is the cause of your ABS fault, this replaces it — diagnose the circuit before ordering. Country of origin: Japan.
Interchange: ABH48 · 536048 · 8951650040 · Manufacturer part number ALH48
This part cross-references / interchanges with the following part numbers:
What vehicles does the ALH48 harness fit?
It's a direct-fit replacement for the front-left position on the 2007 and 2009 Lexus LS460 (All engines). These are two separate model years, so confirm your exact year in the Buyer's Guide tab.
What does this ABS wheel speed sensor wiring harness do?
It connects the vehicle's existing ABS speed sensor to the vehicle wiring, carrying the wheel-speed signal to the control module so the system can monitor that wheel.
Are mounting grommets and clips included?
Yes. OE-location grommets and wire clips are included on the harness for proper mounting and routing during installation.
What connectors and terminals does it have?
It has 2 oval connectors with female and male genders and 4 female blade-plug terminals, and measures 867 mm in length.
Will replacing this harness clear my ABS warning light?
Only if a damaged or corroded harness is the cause. An ABS fault can have other sources, so diagnose the circuit and sensor before replacing this part.
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
