Standard Ignition ABS Wheel Speed Sensor Wiring Harness,ABS Wheel Speed Sensor P/N:ALS513
Standard Motor Products
Standard Ignition ALH73 rear sensor for the 2000-2014 Chevrolet Impala and other vehicles is an ABS speed sensor wire harness that connects to the existing ABS speed sensor and the vehicle wiring. It carries an accurate wheel speed signal to the vehicle control module, which uses it to compensate for more controlled braking performance.
A lit ABS warning light or a traction control fault can point to a problem in the wheel speed signal path. These signs alone do not prove this harness is the problem, since a faulty wheel speed sensor can trigger similar warnings.
It is a direct-fit OE replacement for a wide range of Chevrolet, Buick, Oldsmobile and Pontiac models, including the 2000-2014 Chevrolet Impala, the 2005-2009 Buick LaCrosse and the 2014-2016 Chevrolet Impala Limited. This listing is one harness, and the vehicle takes two. Open the "Vehicles it fits" section and check your exact model and engine before you order.
Fit and size
Build and materials
One antilock brake speed sensor harness. Mounting hardware and a dust shield are not included, so plan on new fasteners where the install needs them.
Product information is for general reference and may contain errors. See our Disclaimer.
Is the Standard Ignition ALH73 the rear sensor harness for a 2005-2009 Buick LaCrosse?
Yes, the Standard Ignition ALH73 is listed for the 2005-2009 Buick LaCrosse, which takes two. For another car, look it up in the "Vehicles it fits" section.
How long is the Standard Ignition ALH73 ABS speed sensor wire harness?
The Standard Ignition ALH73 harness is 1,019 mm long. It has three connectors and 4 + 2 + 2 male blade terminals.
Do these rear ABS speed sensor harnesses come with mounting hardware?
No, mounting hardware and a dust shield are not included; this rear harness is one antilock brake speed sensor harness with OE location grommets and wire clips already on it.
How can I tell if an ABS speed sensor wire harness is damaged?
Cracked insulation, frayed wires or a damaged connector are signs of a damaged harness, and a shop can test the circuit. An ABS warning light is one thing a driver may notice.
Do the grommets and clips on the Standard Ignition ALH73 matter for installation?
Yes. The Standard Ignition ALH73 has OE location grommets and wire clips on the harness for mounting and routing, which saves technicians time.
No reviews yet — be the first to review this product.
Write a Review
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.