Standard Ignition Automatic Transmission Control Solenoid P/N:TCS131
Standard Motor Products
Standard Ignition TCS393 transmission control solenoid for the 2006-2018 Ford E-450 Super Duty and other vehicles blocks or vents fluid pressure inside the transmission on command. Resistance and inductance are matched to OE for proper fit, form and function, and every unit gets 100% end-of-line testing.
Harsh or delayed shifts, or a transmission that stays in one gear, can mean an automatic transmission control solenoid is failing. Before you replace the solenoid, rule out the transmission fluid, the wiring harness and the connector first, since each of them can cause shift problems too.
The 2006-2018 Ford E-450 Super Duty, the 2016-2018 Ford F-53 Motorhome Chassis and the 2004-2016 Ford E-350 Super Duty all take this transmission control solenoid, and so do other vehicles.
Fit and size
Build and materials
This listing holds one transmission control solenoid, and each vehicle takes one. Gaskets, hardware, mounting brackets and a wiring harness are not included, so plan on new gaskets and fasteners rather than reusing the old ones.
Interchange: TCS316 · TCS936 · 3C3Z7J136AA
Product information is for general reference and may contain errors. See our Disclaimer.
This part cross-references / interchanges with the following part numbers:
Does the Standard Ignition TCS393 fit the 2006-2018 Ford E-450 Super Duty?
Yes, Standard Ignition TCS393 fits the 2006-2018 Ford E-450 Super Duty. It fits other vehicles too, so if yours isn't named here, look up your year and model in the "Vehicles it fits" section.
Does the Standard Ignition TCS393 come with a gasket or wiring harness?
No. Standard Ignition TCS393 is one transmission control solenoid; gaskets, hardware, mounting brackets and a wiring harness are not included.
What kind of connector does this transmission control solenoid have?
This transmission control solenoid has one rectangular female connector with two male blade terminals, attached by plugging in. The connector and terminals match OE for a precise harness connection.
Could a stuck transmission control solenoid make my transmission stay in one gear?
Yes, a pintle that isn't moving to block or vent fluid pressure can leave the transmission in one gear, though a fault elsewhere in the transmission can look alike. A shop can test the circuit and fluid pressure.
Does the Standard Ignition TCS393 replace number 3C3Z7J136AA?
Yes, 3C3Z7J136AA is one of the numbers Standard Ignition TCS393 replaces, along with TCS316 and TCS936.
No reviews yet — be the first to review this product.
Write a Review
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.