Standard Ignition Clutch Starter Safety Switch P/N:NS-119
Standard Motor Products
Designed to let the starter engage only when the clutch pedal is pressed, the Standard Ignition Clutch Starter Safety Switch NS-121 helps keep a manual-transmission vehicle from being started in gear. It fits many vehicles, among them the 1998 Chevrolet C1500, 1998 Chevrolet K1500 and 1996-2003 Chevrolet Blazer, as a direct-fit replacement for the listed applications. See the "Vehicles it fits" section for the full list and engine details.
The switch works in the starting circuit and is operated by the clutch pedal. It completes the circuit when the pedal is pushed down, so the starter can crank only with the clutch disengaged.
Signs this part may need replacing: the engine does not crank with the clutch fully pressed, starting is intermittent, or the starter engages without the pedal down. Other starting-circuit faults can cause the same symptoms, so diagnose the cause before replacing the switch. If a failed clutch switch is the cause, the NS-121 replaces it.
Interchange: S26054 · 8850 · DR4078 · NS5547 · 11516184 · 17085811
Product information is for general reference and may contain errors. See our Disclaimer.
This part cross-references / interchanges with the following part numbers:
What does the NS-121 clutch starter safety switch do?
It works in the starting circuit and is designed to let the starter crank only when the clutch pedal is pressed. This helps prevent the vehicle from being started in gear.
Is this Blazer switch right for my 1996-2003 Chevrolet Blazer?
The 1996-2003 Chevrolet Blazer is one of its listed direct-fit applications. Check the "Vehicles it fits" section to confirm your exact vehicle.
Does it fit the 1998 Chevrolet C1500 and K1500?
Yes. The 1998 Chevrolet C1500 and 1998 Chevrolet K1500 are both among its listed applications, and the "Vehicles it fits" section has the full list.
What are signs a clutch starter safety switch may need replacing?
Common signs are no crank with the clutch fully pressed, intermittent starting, or a starter that engages without the pedal down. Diagnose the starting circuit first, because other parts can cause these symptoms.
How is the NS-121 built and tested?
It uses copper alloy conductors for low resistive losses. Standard Ignition tests every unit for both mechanical and electrical switching performance.
No reviews yet — be the first to review this product.
Write a Review
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.