Lock and unlock the driver-side rear door on command with the Standard Ignition Door Lock Actuator DLA-609. It's cataloged for the rear left door position on the 1993-1998 Jeep Grand Cherokee, delivering a direct-fit replacement for a worn or dead actuator on the listed application.
Signs the original actuator may need replacing include a door that no longer locks or unlocks from the switch or remote, a unit that hums or clicks without moving the latch, or intermittent operation at that door. If a failed actuator is the cause of your power-lock trouble, this unit replaces it; diagnose the switch, wiring, and latch first to confirm the actuator is the fault before replacing.
Manufacturer part number DLA-609 (also DLA609).
Which door does the DLA-609 fit?
It is cataloged for the rear left door position on the 1993-1998 Jeep Grand Cherokee. Install it on that corner of the vehicle.
What does a door lock actuator do?
It converts the electrical signal from your lock switch or key fob into the mechanical motion that locks and unlocks the door latch.
What vehicles does this fit?
It is a direct-fit replacement for the 1993-1998 Jeep Grand Cherokee. See the Buyer's Guide tab to confirm fitment for your vehicle.
What are signs this actuator may need replacing?
A door that won't lock or unlock from the switch or remote, a unit that hums or clicks without moving the latch, or intermittent operation at that door.
Should I diagnose before replacing?
Yes. Check the lock switch, wiring, and latch first to confirm the actuator is the fault. If the actuator is the cause, this unit replaces it.
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
