Standard Ignition Engine Camshaft Position Sensor Connector P/N:S2870
$23.99
(You save)
Keep the camshaft position signal flowing with the Standard Ignition Engine Camshaft Position Sensor Connector S2870, the electrical pigtail that joins your vehicle's wiring harness to the camshaft position sensor. It's a direct-fit replacement across a wide range of Audi, Porsche and Volkswagen applications — including the 1998-2006 Volkswagen Beetle, 1998-2015 Volkswagen Jetta, 2002-2004 Volkswagen Passat, 2004-2006 Audi TT Quattro, 2005-2009 Audi A8 Quattro and 2004-2006 Porsche Cayenne. See the Buyer's Guide tab for the full list of covered vehicles.
Purpose-built connector: provides a clean, secure electrical connection between the harness and the camshaft position sensor.
Direct-fit replacement: installs on the listed applications to replace a corroded, cracked, or melted original connector.
Signal integrity: a sound connection helps the sensor pass its reading to the engine control module.
If a damaged or corroded connector is the cause of an intermittent camshaft-position signal, hard start, stall, or a related check-engine code, this replaces the faulty original. Diagnose the sensor and circuit first, since those symptoms can have other causes. Quantity used varies by vehicle — several applications call for two or four connectors — so confirm how many your engine needs. Manufacturer part number S2870.
Frequently Asked Questions
What does this part do?
It's the electrical connector that links your vehicle's wiring harness to the camshaft position sensor, providing the connection the sensor needs to send its signal to the engine control module.
Will this fit my vehicle?
It's a direct-fit replacement for many Audi, Porsche and Volkswagen models, such as the 1998-2015 VW Jetta and 2005-2009 Audi A8 Quattro. Check the Buyer's Guide tab for the full application list.
How many connectors do I need?
Quantity varies by vehicle — some applications use one connector, while others call for two or four. Confirm the correct quantity for your specific engine before ordering.
What are signs this connector may need replacing?
Corroded, cracked, or melted terminals, or an intermittent camshaft-position signal, hard start, or stall. Diagnose the sensor and circuit first, since these symptoms can have other causes.
What is the manufacturer part number?
This is Standard Ignition manufacturer part number S2870, an Engine Camshaft Position Sensor Connector.
Write a Review
STANDARD MOTOR PRODUCTS
Standard Ignition Engine Camshaft Position Sensor Connector P/N:S2870
Camshaft Sensor ConnectorOur components are manufactured to meet exact OE standards, ensuring high-quality products. We produce them in facilities certified to TS16949 and ISO9001 standards, designed...
Camshaft Sensor ConnectorOur components are manufactured to meet exact OE standards, ensuring high-quality products. We produce them in facilities certified to TS16949 and ISO9001 standards, designed...
WARNING:
These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov.
