Keep your engine's cooling fan cycling on cue with the Standard Ignition Engine Cooling Fan Switch TS-223. This thermal switch installs as a direct-fit replacement for the 1985-1993 Volkswagen Cabriolet, 1988-1992 Volkswagen Golf, 1987-1992 Volkswagen Jetta, 1990-1994 Volkswagen Passat, and 1984-1989 Volkswagen Scirocco (engine: All). It senses coolant temperature and signals the fan controller, so the fan runs when the engine needs it.
- Thermal actuation: a custom wax formulation expands when heated to activate the electrical contact and transfer the signal to the fan controller.
- Calibrated & tested: factory-calibrated to make electrical contact at its specified lower-temperature set point, and open at idle.
- Connection: single male blade terminal with a round male connector, 10MMX1.00 thread, and 12-volt operation.
- Build: metal housing with a gold finish; wiring harness, mounting hardware, and brackets are not included.
If a failed fan switch is the cause of a fan that won't cycle, this replaces it. Made in Spain.
Interchange: 053919521 · TFS592 · SW573 · FS127 · 191919521B · 191919521D
Manufacturer part number TS-223
This part cross-references / interchanges with the following part numbers:
Frequently Asked Questions
What does this cooling fan switch do?
It senses coolant temperature and, using a wax formulation that expands when heated, closes an electrical contact that signals the fan controller to run the cooling fan.
Which vehicles does the TS-223 fit?
It's a direct-fit replacement for the 1985-1993 VW Cabriolet, 1988-1992 Golf, 1987-1992 Jetta, 1990-1994 Passat, and 1984-1989 Scirocco (engine: All). See the Buyer's Guide tab to confirm your vehicle.
Does it include a wiring harness or mounting hardware?
No. The wiring harness, mounting hardware, and brackets are not included with this switch.
What are signs this switch may need replacing?
Signs may include the cooling fan not turning on as coolant heats up, or the fan running constantly. These symptoms can have other causes, so diagnose the cause before replacing.
What are its connection specs and where is it made?
It has a single male blade terminal, a round male connector, a 10MMX1.00 thread, and 12-volt operation. Country of origin: Spain.
Write a Review