Standard Ignition Engine Variable Valve Timing (VVT) Solenoid P/N:VVT221
Standard Motor Products
Standard Ignition VVT140 right variable timing solenoid for the 2007-2012 Nissan Sentra 4-cylinder 2.0L and other vehicles regulates oil flow to the camshaft phaser to adjust valve timing.
A worn solenoid can show up as a rough idle, a check engine light or weaker acceleration. Before you replace the engine variable timing solenoid, rule out low or dirty oil, a damaged connector or wiring, and other timing-system faults that can look much the same. A shop can test the circuit.
The 2007-2012 Nissan Sentra 4-cylinder 2.0L, the 2007-2012 Nissan Versa 4-cylinder 1.8L and the 2013-2021 Nissan NV200 4-cylinder 2.0L are among the many vehicles this direct-fit solenoid fits. If your car is not named here, look it up by year, make and model in the "Vehicles it fits" section.
Fit and size
Build and materials
One right variable timing solenoid. This listing is a single right-side solenoid, and this position takes one. Gaskets and mounting hardware are not included, so plan on new bolts and gaskets rather than reusing the old ones.
Interchange: 35-1039
VV1040 · TS1037 · TS1038 · VVTA34 · VVS1539 · 19316368 · 23796EN20A · 23796ET00A
Product information is for general reference and may contain errors. See our Disclaimer.
This part cross-references / interchanges with the following part numbers:
Does the Standard Ignition VVT140 fit a 2007-2012 Nissan Versa 4-cylinder 1.8L?
Yes. The Standard Ignition VVT140 right variable timing solenoid fits the 2007-2012 Nissan Versa 4-cylinder 1.8L and the 2013-2021 Nissan NV200 4-cylinder 2.0L.
Do I need to buy gaskets separately for the VVT140 variable timing solenoid?
Yes. Gaskets and mounting hardware are not included; this listing is one right solenoid.
What voltage and connector does the Standard Ignition VVT140 use?
The Standard Ignition VVT140 is a 12 V electromagnetic solenoid with one rectangular female connector and two male blade terminals.
What size is the shaft on this variable timing solenoid?
The shaft is 18 mm (0.7 in) in diameter. The body measures 93 mm in height, 24 mm in length and 24 mm in width.
Does the VVT140 replace number 23796EN20A?
Yes. 23796EN20A is one of the numbers this solenoid cross-references to, along with 23796ET00A and VV1040.
No reviews yet — be the first to review this product.
Write a Review
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.