Standard Ignition Engine Variable Valve Timing (VVT) Solenoid P/N:VVT125
Standard Motor Products
Standard Ignition VVT426 VVT solenoid for the 2012-2016 Volvo S60 5-cylinder 2.5L and other vehicles controls oil flow in the engine's variable valve timing system. This is the exhaust-position unit, specifically engineered for Volvo engines.
A worn variable valve timing solenoid can go along with a rough idle, weaker power or a check engine light. Before you replace it, rule out low or dirty engine oil and a damaged connector, since either could be behind the same symptoms.
Beyond that car, it is a direct-fit OE replacement across a wide range of Volvo models, including the 2016 Volvo S60 Cross Country 5-cylinder 2.5L and the 2015-2016 Volvo V60 5-cylinder 2.5L.
Fit and size
Build and materials
One VVT solenoid; the vehicle takes one. Gaskets and mounting hardware are not included, and the old ones may not be reusable.
Interchange: 35-1612
VV1326 · VVTB10116 · VVS1982 · 312162220 · 360026880
Product information is for general reference and may contain errors. See our Disclaimer.
This part cross-references / interchanges with the following part numbers:
Is this the right Volvo S60 vvt solenoid for the 2012-2016 model with the 5-cylinder 2.5L?
Yes. Standard Ignition VVT426 is listed for the 2012-2016 Volvo S60 5-cylinder 2.5L and for other Volvo models. Look up your own car in the "Vehicles it fits" section.
Are gaskets and bolts included with this VVT solenoid?
No. The Standard Ignition VVT426 listing is one VVT solenoid. Gaskets and mounting hardware are not included, so plan on getting them separately.
What kind of connector does this VVT solenoid have?
It has one female plug-in connector with a rectangular, oval shape and two male pin terminals. The solenoid runs on 12 volts and is electromagnetically activated.
Can a bad exhaust-side VVT solenoid trigger a check engine light?
Yes, it can. A faulty solenoid may set a code, and a rough idle or reduced power are other possible signs. A shop can scan the codes and test the solenoid.
Do the anodized components on this VVT solenoid resist oil sludge?
Yes. The anodized components resist sludge buildup for consistent performance in extreme conditions, and each solenoid goes through 100% end-of-line testing.
No reviews yet — be the first to review this product.
Write a Review
WARNING: These products can expose you to chemicals including lead and phthalates, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.